ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 79)

Section 12 – J7 Trigger Outputs

12-5

NOTE:

The tamper switch need not be

used for UL Household Fire or

Burglary installations. The

tamper switch must be

connected to an EOLR

supervised zone programmed

for trouble by day/alarm by

night (type 05) response as

shown for UL Commercial

Burglary installations.

When the keyswitch is

removed from the wall, the

tamper switch will open causing

a fault (trouble or alarm) on

zone 6 and causing the panel

to disable keyswitch operation

until the partition is disarmed

from a console.

RED

820ohms

YELLOW

RED

(ARMED)

BLACK

820ohms

WHITE

GREEN

(READY)

TAMPER SWITCH

(CONTACTS CLOSE WHEN

SWITCH DEPRESSED. SEE NOTE)

BROWN BROWN

BLUE BLUE

LOCK SWITCH

(NORMALLY OPEN)

2K EOLR

TO AUX POWER

(TERMINAL 6)

TO J7/OUT 2

TO ZONE 7(+)

(TERMINAL 20)

TO ZONE 6(–)/ZONE 7(– )

(TERMINAL 19)

TO ZONE 6(+)

(TERMINAL 18)

TO J7/OUT 4

TO AUX POWER

BROKEN LINES REPRESENT

INSTALLER WIRING CONNECTIONS

Figure 12-4: Remote Keyswitch Wiring

Programming for the Remote Keyswitch

1. With at least one 2-line alpha keypad 6139 wired and set to a proper address, power up

the system temporarily by plugging the AC transformer into a 120VAC outlet (previously

wired to the control).

2. Enter Data Field Programming Mode: [Installer Code] + 8 0 0 0

Program the following data fields:

*15 KEYSWITCH ENABLE: Assign the keyswitch to a partition (1-8). Enter 0 to

disable.

*40 OPEN/CLOSE REPORT ENABLE: Enter 1 to enable Open/Close report for the

keyswitch, otherwise enter 0.

1*46 AUXILIARY OUTPUT ENABLE: Set to "0" (factory default)

*93 ZONE PROGRAMMING: Zone 7 must be assigned a non-zero response type.

3. Press *99 to exit program mode.

The VISTA-128B allows 2 modes of keyswitch operation. When field *15 is set to a partition

(1-8), the keyswitch operates as follows:

With System Disarmed and No Alarms Present:

A momentary short across zone 7 will arm the partition in the AWAY mode, and a short held

for more than 10 seconds will arm the partition in the STAY mode. A subsequent short will

disarm the partition. The keyswitch LEDs will indicate that the partition has armed (see

table that follows).

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 251 252

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 79

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-128B