ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 133)

Section 22 – Data Field Descriptions

22-13

1*42 CALL WAITING DEFEAT

[0]

Enter 1 for the panel to defeat Call Waiting on the first attempt (DO NOT enable unless

Call Waiting is being used).

Otherwise, enter 0.

1*43 PERMANENT KEYPAD DISPLAY BACKLIGHTING (partition-specific)

[0]

Enter 1 if backlighting for the keypad display is to remain on at all times.

Enter 0 if the display should remain unlit unless a key is pressed. The backlighting then

turns off again after a period of keypad inactivity. Note that when a key is pressed,

display backlighting turns on for all keypads in that partition.

1*44 WIRELESS KEYPAD TAMPER DETECT

[0]

Enter 1 to enable tamper detection on wireless keypad.

Enter 0 if tamper detection is not desired. If this feature is enabled, any attempt to

tamper by means of many trial entries at a wireless keypad will be blocked by the

control panel. If more than 40 key depressions are received without a valid sequence

(arm, disarm, etc.), the Control panel will disable the wireless keypad. The inhibit is

removed once a valid key sequence is received from a wired keypad.

1*45 EXIT DELAY SOUNDING (partition-specific)

[0]

Enter 1 if beeping from the keypads during exit delay are desired. Enter 0 for no

keypad sound during exit delay.

1*46 AUXILIARY OUTPUT MODE

[0]

Enter

if ground start output is required.

Enter

if the auxiliary output will be used to produce an open/close trigger (produced

only if ALL partitions are armed).

Enter

if the auxiliary output will be used to produce keypad-like sounding at an

auxiliary sounder (ex. 706-12). This option applies only to the partition enabled in field

*15.

Enter

if AAV module is being used.

NOTE:

Only one of the above options may be active within the system.

1*47 CHIME ON EXTERNAL SIREN (partition-specific)

[0]

Enter 1 for chime annunciation using the external alarm sounder. If not desired, enter

1*48 WIRELESS KEYPAD ASSIGNMENT

[0]

Enter the partition in which RF keypad is used, 1-8.

Enter 0 if no RF keypad is used.

1*49 SUPPRESS TX SUPERVISION SOUND

[1]

Enter 1 to disable trouble sounding for transmitter check-in failure.

Enter 0 if audible trouble sounding is desired.

Must be

for UL.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 251 252

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 133

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-128B