ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 74)

VISTA-128B Installation Instructions

11-4

Programming Audio Alarm Verification Module Options

1. With at least one 2-line alpha keypad (6139) wired and set to a proper address,

temporarily apply power to the system.

2. Enter Data Field Programming Mode: [Installer Code] + 8 0 0 0.

3. Program the following data fields:

*45 PRIMARY DIALER FORMAT: Set for 1 (Contact ID).

1*46 AUXILIARY OUTPUT ENABLE: Set for 3 (unless using 4204 Relay Module).

1*60 ZONE 5/AUDIO ALARM VERIFICATION: Set for 1.

Set CANCEL REPORT to a non-zero digit in System Group #1 in Report Code Programming

in the #93 Menu Mode.

If you need more information about actual programming procedures, see

The Mechanics of

Programming

section.

4. Zone 5 must be programmed for response type 10 and the EOLR must be removed,

regardless of whether or not EOLRs have been enabled in field *41. Zone 5 is no

longer available as a protection zone.

5. If using a 4204 relay instead of the J7 trigger, program the relay to trip on Zone

Type/Sys. Op. 60 Audio Alarm Verification (see the Relay Outputs and Powerline Carrier

Devices section).

6. Press *99 to exit Program Mode.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 251 252

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 74