ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 155)

Section 23 - #93 Menu Mode Programming

23-17

[2] Adds or removes an "s" or " 's " to a vocabulary word.

[6] Switches between alphabet and actual word list; used to accept entries.

[8] Saves the zone description in the system's memory.

[#] [#] plus zone number displays the description for that zone.

2. Enter the zone number to which you want to assign a descriptor.

For example key [∗]001 to begin entering the description for Zone 1, (key [∗]002 for

Zone 2, [∗]003 for Zone 3 etc.). The following will be displayed: * ZN 001 A.

Note that the first letter of the alphabet appears after the zone number, and that the

zone number is automatically included with the description.

3. Enter the descriptor for that zone.

Use one of two methods as follows:

(Assume, for example, that the desired description for Zone 1 is BACK DOOR)

a) Press [#] followed by the 3-digit number of the first word from the fixed

dictionary shown later in this section (e.g., [0][1][3] for BACK).

Press

in order to accept the word and proceed, or press

to store the

complete descriptor and exit;

b) Select the first letter of the desired description (note that "A" is already

displayed). Use the 3 key to advance through the alphabet and the 1 key to

go backward.

Press 3 key repeatedly until "B" appears (press 1 to go backwards if you

happen to pass it), then press 6 to display the first available word beginning

with B.

Press 3 repeatedly to advance through the available words until the word

BACK is displayed.

To add an "s" or " 's," if you need to, press

. The first depression adds an "s," the second

depression adds an " 's, " the third depression displays no character (to erase the character), the

fourth depression adds an "s," etc.

4. Accept the word.

To accept the word, press 6, which switches back to the alphabet list for the next

word, or press 8 to store the complete descriptor and then exit.

5. Select the next word.

For selection of the next word (DOOR), repeat step 3a (word #057) or 3b, but selecting

the word "DOOR.”

To accept the word, press 6, which again switches back to alphabet list.

6. Store the descriptor.

When all desired words have been entered, press 8 to store the description in

memory.

To review the zone descriptors, key [#] plus zone number (e.g., #001).

To edit zone descriptors, key [∗] plus zone number (e.g., *001)

Exit Zone Description Mode: enter 000.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 251 252

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 155

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-128B