ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 142)

VISTA-128B Installation Instructions

23-4

000 INPUT S/N: L

Axxx-xxxx

If 1 is entered, the system will prompt for the unit’s serial

number. Enter the program tool’s serial number using one of

the following methods:

a) Enter the 7-digit serial number for the transmitter.

Press any button on the transmitter. The keypad

should beep three times and display the serial number

of the tool.

000 PROG AS BR: 3

A123-4567 3

In this example, the serial number is A123-4567. Once

enrolled, the upper left-hand button of the program tool can be

pressed to ready the system for enrolling a device into the

system.

The serial number for the program tool will only remain in the

system until the programming mode is exited. (Entering

✱

will not delete the tool.)

Press [*] to continue or press the [#] key to back the system up

to the “PROGRAM TOOL? “ prompt.

ENTER ZN NO.

000 = QUIT 010

Zone 010 entered

↑

Enter the 3-digit zone number that you wish to program. As an

example, zone 010 is shown here

✝

Press [*] to continue.

010 ZT P RC INL

00 – –– –– –

A display will appear, showing a summary of that zone's

programming. ZT=Zone Type, P=Partition, RC=Report Code,

IN=the input type of device, and L=the device's loop number to

which the sensor is connected. Some devices can support more

than one zone by means of individual loops (for example, 5801,

5804, 5816, 5817, etc.). If the zone is not programmed, the

display will appear as shown here. If checking a zone's

programming, and it is programmed satisfactorily, press [#] to

back up one step and enter another zone number, if desired.

Otherwise, press [*] to continue.

✝

If using a V-Plex relay module, program the relay zone number only if either of the

following is true:

Supervision of the relay is desired (enter response type 05).

You are using

only

the relay output on the device without using the protection zone.

This allows enrollment of the serial number of the relay module, which is required for

the control to identify and communicate with the respective relay output. (If using

the protection zone on the module, you need only enter the protection zone number

for enrolling the serial number. See Relay Programming “V-PLEX ZONE #” prompt).

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 251 252

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 142

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-128B