ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 126)

VISTA-128B Installation Instructions

22-6

*43 DIAL TONE DETECTION

[1]

Determines whether the control will wait for a true dial tone before dialing, or if it will

wait for a predetermined delay before dialing (delay is programmed in Dial Tone Pause

field *42). The latter may be necessary in high-noise environment telco networks where

noise can be confused with dial tone, resulting in premature dialing.

Enter 1 for true dial tone wait. If no dial tone is detected, will dial at end of pause

programmed in field *42.

Enter 0 to pause for seconds entered in field *42, then dial.

*44 RING DETECTION COUNT [00]

Only applicable if using a 4285/4286 VIP Module and/or if station-initiated downloading

will be used.

Enter 00 to disable ring detection.

Enter 01-14 for ring counts of 1-14.

Enter 15 to select Answering Machine Defeat Mode, which allows the system to receive

calls even when a telephone answering machine is connected to the same phone line. In

the Answering Machine Mode, the caller should let the phone ring once, then hang up,

and call again within 30 seconds. The system, upon hearing one ring followed by

nothing, will not answer the first call, but will ready itself to pick up on the first ring of

the next incoming call that is received within 30 seconds (i.e., the downloader calling

again). Must be

for UL commercial burglary installations.

Note:

Do not enter 00 if a 4285/4286 is installed.

*45 PRIMARY FORMAT

[0]

This field selects the reporting format for use on the primary telephone number.

Enter the appropriate number for the primary format as follows:

=Low Speed;

=Contact ID;

=ADEMCO High Speed;

=ADEMCO Express

*46 LOW SPEED FORMAT (PRIMARY)

[0]

Enter the appropriate value: 0=ADEMCO Low Speed; 1=Sescoa/Radionics

*47 SECONDARY FORMAT

[0]

This field selects the reporting format for the secondary telephone number.

Enter the appropriate number for the secondary format as follows:

=Low Speed;

=Contact ID;

=ADEMCO High Speed;

=ADEMCO Express

*48 LOW SPEED FORMAT (SECONDARY)

[0]

Enter the appropriate value: 0=ADEMCO Low Speed; 1=Sescoa/Radionics

*49 CHECKSUM VERIFICATION [0,0]

Enter 1 for either or both primary/secondary formats to send a verification digit to

validate the message at the receiver without having to send two message rounds.

Selection is valid for 3+1, 4+1, and 4+2 reports.

Enter 0 if not desired.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 251 252

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 126

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-128B