ADEMCO VISTA-128B Guia de preparacion descargar pdf (Pagina 59)

Section 8 – Wireless Zone Expansion

8-5

For button-type transmitters (wireless keys), such as the 5804, 5804BD, 5803, and 5801, you

must assign a unique zone number to each individual button used on the transmitter. Each

button on the transmitter also has a pre-designated loop or input number, which is

automatically displayed when learned.

Transmitter Supervision

Except for some transmitters that may be carried off premises (5802, 5802CP, 5803, 5804,

5827, and 5827BD), each transmitter is supervised by a check-in signal that is sent to the

receiver at 70–90 minute intervals. If at least one check-in is not received from each

supervised transmitter within a programmed period (field 1∗31), the “missing” transmitter

number(s) and “CHECK” or “TRBL” will be displayed.

The supervision for a particular transmitter that may be carried off the premises (5801,

5802MN) may be turned off by learning it as a “UR” (unsupervised RF) type, as described

later in this manual.

5800 Series transmitters have built-in tamper protection and will annunciate a “CHECK” or

“TRBL” condition if covers are removed.

Transmitter Input Types

All of the transmitters described have one or more unique factory-assigned input (loop) codes.

Each of the inputs requires its own programming zone (e.g., a 5804’s four-button inputs

require four programming zones).

Transmitters can be programmed as one of the following types:

Type Description

(Supervised RF)

Sends periodic Check-in signals, as well as Fault,

Restore, and Low Battery signals. The transmitter must

remain within the receiver’s range.

(Unsupervised RF)

Sends all the signals that the RF type does, but the

control does not supervise the Check-in signals. The

transmitter may therefore be carried off-premises.

(Unsupervised Button RF)

These only send Fault signals. They do not send Low

Battery signals until they are activated. The transmitter

may be carried off-premises.

Transmitter Battery Life

• Batteries in the wireless transmitters may last from 4 to 7 years, depending on the

environment, usage, and the specific wireless device being used. Factors such as

humidity, high or low temperatures, as well as large swings in temperature may all

reduce the actual battery life in a given installation.

• The wireless system can identify a true low battery situation, thus allowing the dealer or

user of the system time to arrange a change of battery and maintain protection for that

given point within the system.

• Some transmitters (e.g., 5802, 5802CP, and 5803) contain long-life but nonreplaceable

batteries. At the end of their life, the complete unit must be replaced (and a new serial

number learned by the control).

• Button-type transmitters (e.g., 5801, 5802, 5802CP & 5803) should be periodically tested

by the installer for battery life.

Do not install batteries in wireless transmitters until ready to learn, as will be indicated under

Programming the RF Transmitters

later in this section.. After learning, batteries need not be

removed.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 251 252

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-128B Guia de preparacion Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-128B