ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 9)

seconds A system-wide EEPROM defined number of alarm

reports for this zone will be allowed to retransmitted (swinger sup-

pression) by the communicator in one armed period, The

communicator will transmit a restoral message when the zone

is restored for a time greater than its physical response time

(less than 1 second).

During the disarmed state, a faulted zone will result in a NOT

READY dwplay. Subsequent depression of the READY key will

cause all the faylted zones to be sequentially displayed, No

communicator reporls will be initiated,

Type 5. BURGLARY PERIMETER, TROUBLE BY DAY/ALARM BY

NIGHT: During the disarmed state (day), faulting the zone will

initiate a “trouble” display and a latched sounder (beeping).

The Control will beep rapidly along with a latched display of the

faulted zone and the word CHECK, Pressing any key will

silence the beeping for 10 seconds. Code + OFF will silence

the beeping but will only clear the display of a zone that had

the fault condition removed.

If a Communication board is used, each trouble will result in a

“trouble” report (if programmed). A trouble restoral message

will be sent as each zone is restored to normal condition. The

maximum number of trouble reports per armed period will be

limited by the system-wide EEPROM number of alarm reports

option (swinger suppression).

During the armed state (night), the local (Control) and external

(if used) alarm sounder will activate and the communicator will

report alarms. A system-wide EEPROM defined number of

alarm reports for this zone will be allowed to be transmitted in

one armed period, Restorals will be sent when the zone is re-

stored for a time greater than its physical response time (less

than 1 second).

Type 6. 24-HOUR SILENT ZONE Sensors assigned to this zone,

when faulted, will initiate a communicator report. There will be

no local displays or alarm sounds. Upon keying Code plus OFF,

there will be a memory indication of the faulted zone.

A system-wide EEPROM defined number of alarm reports for

this zone will be allowed to be transmitted (swinger suppres-

sion) by the communicator until an OFF sequence is per-

formed. The communicator will transmit a restoral message

when the zone is restored for a time greater than its physical

response time (less than 1 second).

During the disarmed state, NOT READY will be displayed if a

sensor is faulted. The burglary portion of the system cannot be

armed if this zone is faulted. An OFF sequence (code plus OFF)

should be performed prior to arming the system or viewing the

faulted zones via the *key,

Type 7. 24-HOUR AUDIBLE ZONE: Faulting a zone of this type will

initiate a loud audible alarm externally and at the Control, an

LCD display, and a (EEPROM selected) communicator report.

Pressing any key will silence the Control sounder for 10

seconds. Keying Code plus OFF will permanently silence the

alarm. A system-wide EEPROM defined number of alarm

reports for this zone will be allowed to be transmitted (swinger

suppression) by the communicator until an OFF sequence is

performed The communicator will transmit a restoral message

when the zone is restored for a time greater than its physical

response time (less than 1 second).

Type 8. 24-HOUR AUXILIARY ZONE Faulting a zone of this type will

initiate a steady alarm sound at the Control, an

ALARM display, and a (EEPROM selected) communicator

report. Pressing any key will silence the Control sounder for 10

seconds. Keying Code plus OFF will permanently silence the

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 83 84

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista 4130XT