ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 5)

Back-up 12V DC Battery

DC Power Pack

Mounted externally. A spectal backbox (4132) is available for mounting

Plug-in Power Pack (DC power converter). Plugs into unstitched 2-prong

the battery in the wall behind the Control. Rechargeable 12-volt, 1.2 AH

110 volt AC outlet providing 24-hour serwce. Power Pack (1350) supplies

Lead Acid.

unregulated 18V DC output (700 mA max) for powering the Control.

The No. 4130XT allows the installer to call it using switched network

phone lines so that the control/communicator can be remotely

programmed and/or commanded from a No 699MD Intelligent

Programmer or an IBM compatible Personal Computer (PC). See Note 2

under Remote Capabilities in this section.

Accessing of the No. 4130XT from a remote location is protected against

compromise by someone attempting to defeat the system, using 4 levels

of security protection:

Security Code Handshake: An 8 digtt Central Station ID code must

be matched between the No. 4130XT and the Central Station.

Hang-up and call back: Calling the No. 4130XT does not directly

allow programming, as a successful handshake merely results in the

No. 4130XT breaking the phone line connection and then calling back

the (internally stored) central station service phone number’.

Data Encrwtion: Data passed between the central station and the

No, 4130X~”is encrypted for security so that it is very difficult for a for-

eign device tapped into the phone line to take over communication

and substitute system compromising Information.

*NOTE: In situations where a service person is on stte and the system is

installed inside a PABX, it is possible to initiate a download from

the protected premises by keying [installer or master security

code] + [#] + [1].

4 Central Station Advisory Note: Any condition that causes the system

to initiate a call back to a telephone number from which it can be

reprogrammed or commanded (in fact, even for a local reprogramming

of the EEPROM) causes a unique report to be sent to the central sta-

tion’s alarm Ioggmg digital receiver.

Equipment Required

At the premises

The No. 4130XT must be used with its No. 4171 XT Communication Inter-

face board if remote programming and/or control is desired.

At the central station (or the installer’s office/home):

● A No. 699MD Intelligent Programmer that incorporates an internal

modem and a No. 695-30XT Program Cartridge.

c An IBM PC compatible computer, a Modem (check with Ademco Factory

Technical Support for the specific brand and model to be used), No.4130PC

Downloading Software Diskette, and appropriate interconnecting cables.

Remote Capabilities (See Note 2)

Programming:

All programming functions accessible from the unit’s keypad or via local

No 693 direct programming.

1 2 3 4 5 6 7 8 9 10 ... 83 84

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista 4130XT