ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 10)

alarm. A system-wide EEPROM dehned number of alarm

reports for this zone will be allowed 10 be transmitted (swinger

suppression) by the communicator untd an OFF sequence is

performed. The communicator will transmit a restoral message

when the zone is restored for a time greater than its physical

response time (less than 1 second).

Type 9. FIRE ZONE: Opens in this zone will result in “troubles”. Shorts

will result in alarms. Note: Zone 1 will support 2-wire Smoke

Detectors (using the EOL resistor configuration): Zones 2

through 8 can be used for heat detectors and pull stations and

for 4-wire Smoke Detectors with external (manual) power inter-

rupt; Zone 9 cannot be used for Fire.

Fire zones may not be bypassed. A fire zone m trouble will not

prevent the burglary system from being armed in any mode

A system-wide EEPROM defined number of alarm reports for

this zone will be allowed to be transmitted (swinger suppres-

sion) by the communicator in one armed period. The communi-

cator will transmit a restoral message when the zone

is restored (less than 1 second).

Type 10. INTERIOR DELAY ZONE: This type of zone will always have

an Entry delay #l and Exit delay HI. Thw zone IS not enabled

after armmg until termination of the (EEPROM defined) Exit

delay #1. If this zone E faulted, three beeps will be emitted by

the Control. If Code + OFF E not entered before termination of

the (EEPROM defined) Entry delay #1, an alarm will be mitlated.

A system-wide EEPROM defined number of alarm reports for

this zone WIII be allowed 10 be transmitted (swinger suppres-

sion) by the communicator in one armed period. The commun-

icator will transmit a restoral message when the zone IS re-

stored for a time greater than its physical response time (less

than 1 second).

During the disarmed state, a faulted contact WIIIresult m NOT

READY being displayed. Subsequent depression of the READY

key will cause all the faulted zones to be sequentially displayed,

but no commurucator reports will be initiated.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 10