
(See Diagram 1, Summary of Connections)
A 24-pin plug-in connector with flying leads is provided to interface the
4130XT to the wired loops, the external alarm sounder, the back-up bat-
tery, to externally powered devices (auxiliary current), and to the plug-in
DC Power Pack,
The 24 flying leads, each 18 inches [46 cm) m length, are umquely color
coded, as shown in Diagram 1 and also in Table C which indicates the
color, usage and pin connection for each lead
Note: Optional 30-ft (9 m) and 15-ft (46 m) wiring harnesses with a 24-
pln connector at one end are ava;lable for interface wiring. Color coding
of wires used In these harnesses is identical to that used w’ the 24-pm
connector with 18-inch leads. Refer to “Optional Accessories” for part
numbers of available wiring harnesses
Grounding the System
A proper earth ground must be provided for the system. The While lead
(pin 11) on the 24-pin connector is the earth ground lead (see Table C).
Connect this lead to a suitable earth ground (a metalhc cold water pipe
or electrical box may be used in some locations).
TABLE C. WIRE ASSIGNMENTS
Wire Color
Usage
Connector Pins Usage
Wke Color
Blue
DC (-)
INPUT (12) (24)
Dc(+) INPUT
Red/Green
(from plug-in
OC PQwer Pack)
(from plug-n
OC Power Pack)
Whtte
EARTH GND (11) (23) BATTERY(+)
Red
Black
BATTERY (-) and (lo) (22)
AUX/REMOTE
Red/Black
REMOTE CONSOLE CONSOLE/EXT
GROUND
ALARM SOUNDER
PWR (+)
Violet
AUX PWR (-) (9) (21)
ExT ALARM
Brown
SOUNDER(-)
Gray
ZONE RETURN (8)
(20)
ZONE 4(+)
Wh(te/Yellow
Tan
ZONE RETURN (7) (19) ZONE 5(+)
White/Green
Whltel Red
ZONE 2(+)
(s) (18)
ZONE 6(+)
Whtte/Blue
Wh!te/Orange
ZONE 3(+) (5) (17)
ZONE 9(+)
While /Black
Whte/ Brown ZONE 1 RETURN (4) (16)
ZONE 7[+)
Wh!lelvmlel
Orange
ZONE t(+)-N C
LOOP (3) (15) ZONE 8(+)
Whfte /Gray
Pink
ZONE RETURN (2) (14)
ZONE l(+)
RediYel[ow
EOLR LOOP
Green
DATA IN
(1) (13)
DATA oUT
Yellow
(Remote Gonsote) (Remote Console)
Comentarios a estos manuales