ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 51)

FUNCTION ADDRESS

SECONDARY

*48

TRANSMISSION

FORMAT

SINGLE MESSAGE

*49

TRANSMISSION WITH

CHECKSUM

VERIFICATION

SESCOA/RADIONICS *5O

SELECTION

DUAL REPORTING

*51

OPEN/CLOSE

*52

REPORTING ENABLE

BY USER CODE

❑

COMMENTS: Same options as Address *46.

Enter O (Ademco Low Speed 1 (SESCOA/Radionics), or 2 (Ademco High Speed)

•1

COMMENTS: When selected, will send verification digit with the message to validate the message

at the receiver without having to send two message rounds. Enter O(NO) or

1 (YES).

NOTE: Selection applies to both primary and secondary phone numbers,

❑

COMMENTS: Enter O if Radionics format is to be used with hexadecimal B-F reporting; enter 1 if SESCOA format

is to be used with only numenc reporlmg (0-9),

NOTE: Selection applies to both primary and secondary phone numbers.

❑

COMMENTS: If selected, will send all reports to both primary and secondary phone numbers.

NOTE: If dual reporting is desired and Ademco High Speed format is to be used at all, it must be selected as both

the primary and secondary transmission formats

Enter O (NO) or 1 (YES)

ilbttllxlnn

COMMENTS: Enter O (disable) or 1 (enable) Determines which user code will send open/close reports. User #7

must be enabled if open/close reporting is desired for keyswitch arming or close reporting is desired for “Quick

Arm” and “Power Up” arm.

NOTE: User #1 must be enabled to permit use of installer code to enter programming mode.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 51