ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 18)

Remote Keyswitch Operation & Wiring

TAB

ISEENOTEBELOW

An optional Remote Keyswitch may be used for remote arming and dis-

arming (this is an installer-programmed option). A normally-open momen-

tary switch is connected across Zone 7 (which must be given up as a

protection zone). A momentary short of the zone will arm the System in

the AWAY mode; it the key is held (short maintained) for over 3 seconds,

the System WIII arm In the STAY mode. When a momentary short E ap-

plied subsequently, the System will disarm. A keyswitch tamper

(normally-closed) switch wired in series with zone 7 will disable keys-

witch operation until the system is next disarmed via a keypad, if acti-

vated. Refer to Diagram 3 for Keyswitch wiring details

NOTE: Regardless whether End-of-Line superwslon IS selected or not (In

Address *4 I ), an end-of-line resistor must still be used for proper

functioning of the keyswltch.

Optional Remote Keypad Connection (4131/4147)

An optional remote keypad (4131 /4147) may be used with the System.

Two 10-pin female connectors have been supplied for keypad interfacing

to the 4130XT Control (see Diagram 1, Summary of Connections) The

two connectors, which are identical, are equipped with color-coded flying

leads that are 12 inches (30 cm) in length.

One of these connectors is attached directly to the mating 10-pin male

SEE

connector on the 4131 /4147 remote kevDad (the connector can only be

WIRING ASSIGNMt NT

TABLE IN TEXT

RECORDING

INSTALLATION

DATA

When all interface

wlrlng is completed,

record w)nng usage

In the spaces pro-

vided on the Wire

Assignment tag at-

tached to the wires

on the 24-pin con-

nector. This will

provide a perman-

ent record of the

lnlerface wiring

connections for

future serwcing,

inserted one way, and will lock in place):”

NOTE

The other connector is connected to the 4130XT Control wa a “straight”

TOREMOVECONNECTORFROMCONTROLBOARD

male-lo-male 10-~in ada~ter (suPrJlied).

AFTERINSERTION.S0UEE2&TABANDPULL

OUTWARD

WITH ASIDEToSIDEROCKINGM0710N

Specific information regarding the use of the adapter and connection to

Diagram 2.

the 4130XT Control is provided in the section entitled MOUNTING THE

24-PIN CONNECTOR WITH FLYING LEADS

4130XT.

(4130XT WIRING INTERFACE)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 83 84

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista 4130XT