ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 20)

The optional Digital Communlcatlon Interface Board IS attached to the

rear of the Control as follows (refer also to Diagram 4).

Remove the back cover on the Control. The securing screw at the left

front of the Control must be removed to release the back cover (see

Diagram 6 for screw location). Discard the back cover, but retain the

screw for use later.

Insert three small plastic standoffs (supplied) into the three holes on

the Control board identified as “A”, “B” and “C” in Diagram 4 Press

them in firmly until they “snap” into place.

Insert the 13-pin male-to-male adapter (supplled) into fhe interface

socket pin holes on the underside of the Commumcation Interface

board, as shown.

Attach the Communication Interface Board to the Control board as fol-

DIG1T4L COMMUNICATION

INTERFACE BOARD

13P1N INTERFACE

CONNECTOR (ADAPTER

/PINS INSERTED FROM

STANDOFFS ,3) u

IN 3 PLACES (HOL D FIRST)

B AND C)

lows. Guide the adapter pins (on the Communication board) into the

interface pin holes on the Control board, simultaneously allowing the

pointed ends of the standoffs to partially enter the holes in the Com-

munication board (shown as “A”, “

B“ and “C” in the Diagram), Before

proceeding, make sure the adapter pins are properly entering the pin

holes on the Control board. Then press the Communication board

down until the connector pins are fully seated and the standoffs

“snap” into place in the Communication board, thus holding the board

securely to the Control.

This completes the installation of the Communication Interface board,

Wiring connections are not made at this time.

[

DO NOT CONNECT THE OUTPUT OF THE 4171XT

TO A FIRE OR POLICE HEADQUARTERS

Diagram

4. INSTALLING THE DIGITAL

COMMUNICATION INTERFACE BOARD

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 20