ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 25)

insert the battery into the box, and make connections to its terminals

as follows, using the two 12-inch (30 cm) Red and Blackheads

(equipped with FAST-ON connectors at one end) that have been sup-

plied. See Diagram 1.

a. Splice the wire end of the RED 12-inch lead to the Red lead (pin 23)

coming from the 24-pin connector (an insulated solderless wire

splice such as Ademco No. 311 may beused). Connect the other

end (FAST-ON connector) of the12-inch REDlead to the positive

(+) terminal on the battery.

b. Splice the wire end of the BLACK 12-inch lead to the Black lead

(pin 10) coming from the 24-pin connector (be sure to use an insu-

lated wire splice). Connect the other end (FAST-ON connector) of

the 12-inch BLACK lead to the negative (-) termmal on the battery

Note For ULListed usage, utilize the 4132-l (optional) battery box

cover. Feed the two battery wires through the two openings in

the cover and insulate their connection to the battery with the

plastic insulators supplied with the 4132-1. Insert the battery

into the 4132 backbox andplacethe 4132-1 cover over the

top of the battery.

4, Pull all interface wiring in the wall through the opening previously

made. Splice the appropriate wires to the 24-pin interface connector

as indicated in Diagram 1 (Summary of Connections) and in Table C

previously. Insulated solderless wire splices (such as Ademco

No. 311 ) may be used for splicing. Check all wire connections care-

fully before splicing.

Note If the optional 15-ft (4.6 m) or 30-ft (9 m) wrong harness has

been used for interface wiring, splices at the Control will not be

necessary since these wiring harnesses are terminated with a

24-pin connector which can be connected directly to the

4130 XT.

5. If a Remote Keypad is being used, splice the field wires in the wall to

the wires on the 10-pin connector supplied for this purpose, being

sure to match wire colors.

6. Attach the interface connector(s) to the Control board as follows, refer-

ring to Diagram 6:

a. Attach the 24-pin connector to the mating interfacing pins located at

the bottom of the Control board.

b. Attach the 10-pin connector (if a Remote keypad is being used) to

the Remote Keypad connector (1O-pin socket) at the top of the Con-

trol board via the “straight” male-to-male adapter supplied.

IMPORTANT Be sure to orient the connector with BLACK lead (pin

1) to the left (when viewing the 4t 30XT from the rear),

as indicated in Diagram 1.

7. On the Digital Communication interface board, attach the interconnecting

wires to its terminal block as follows, referring also to Diagram 6:

Communication Interface

Wire

Board Terminal

Assignment

Ground Start

●

;

Incoming Phone Line (Tip)

Incoming Phone Line (Ring)

Handset (Ring)

Handset (Tip)

●Connect to BLUE lead on 675 Ground Start Module.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 83 84

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista 4130XT