ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 69)

FUNCTION

ALARM COUNT

TEST REPORT

INITIATION TIME

ADDRESS

*82

*83

ADEMCO HIGH SPEED

●84

FORMAT USED ON

WATS LINES

DO NOT USE ’85

ZONE EXPANDER

*86

TYPE SELECTION

❑ o

COMMENTS: Enter 01-15.

This option limits the number of messages Alarms or Troubles) sent for a specific channel in an

armed period (Swinger Suppression) before additional reports from that channel are inhibited. This

selection is system-wide.

❑ n

COMMENTS: Enter the time in hours from the time that the programming mode is exited that the

first test report shall be transmitted. 00 entry signifies immediately upon exiting. 01-31 represents

the range in hours that can be selected,

❑

COMMENTS: Enter 1 if Ademco High Speed Format (either traditional or 4+2 versions) will be

transmitted on 800/WATS lines where satellite links may be used. Enter O if other formats are

selected or if local telco lines are being used.

•1

0 MUST BE ZERO

COMMENTS: This field is otherwise used for subzone control enable. It is recommended that a

4130NI be used to perform that function instead, for monetary savings.

❑

COMMENTS: Enter 1 if No. 4208 Eight Zone Expander is being used. Enter O if other VECTOR type

RPMs are being used to expand the number of zones. Imporianti See the section on an earlier page

entftled “Zone Expansion” for proper configuration of the No. 4208.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 69