ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 78)

Wiring Connections:

When the Security Control is cabinet-mounted, the flylng leads from the

24-pin connector are connected to the interface wires via the terminal

blocks provided, as shown in Diagram B. The 12-volt back-up battery is

also installed in the cabinet, and connected to the appropriate terminals

on TB3, using the two 12-inch (30.5 cm) leads supplied (Red and Black),

as shown. The wiring connections are essentially the same as mdlcaled

in Diagram 1 (Summary of Connections diagram) except for the termmal

blocks shown in Diagram B which are used in place of splices.

instructions for connection of the optional Remole Keypad and install-

ationand wiring of the digital communication interface board, 4152LM

Loop Module and 4208 Zone Expander are provided in a previous sec-

tion of this manual (see Index),

After all wiring connections are completed, plug the 24-pw interface

connector into the rear of the Control.

INSERT NAMEPLATE

INTO REcESSED

AREA ICOVERS SCREW)

r---+ I

NO.6x tSELF-

TAPPING 5CREW

{INSERT FROM FRONT)

Vl}~ A

CONTROL

\FLANGESINFRONT

DOOR OF CABINET [2)

No. ‘1X l/~~ELF-

TAPPING SCREW

IINSERT FROM REAR)

Diagram A. MOUNTING THE 4130XT

IN CABINET

No. 4134-8

—

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 78