ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 12)

Zone expansion to an additional 8 zones is achieved by first Installing the

optional No. 41 52LM Loop Module onto the No. 4171 XT (after [t has been

installed). The No. 4152LM can then be connected to a No. 4208 Eight

Zone &pander by a single pair of w!res providing both power and signal-

ing. Path of the 8 zones on the No. 4208 can be programmed from the

various types described in this manual that are available for use on the

basic.9 zones, wdh one exception. There IS no ability to support 2 wire

smoke detectors on any of the zones available in the No. 4208 Zone

Expander The No. 4208 Zone Expander may be located near the No.

4130XT or remotely from )t. The two wire run to it should utihze twisted

pair wiring and should not be run in,close proximity to profected pre-

mises intercom wiring [at least a 3-inch (8 cm) separation]. For the max-

imum wiring run permissible to the zone expander for various wiring

gauges, see the Specifications Section relatwe to the No. 4208 Zone

Expander later in this manual.

IMPORTANT In order to utilize the No 4208 to obtain zones 10-17, that

product’s DIP switches must be set as follows:

2 3

ON ON ON OFF

noun

(as If set for sensor numbers 113-120, as cited in the instructions for the

No 4208)

Installation instructions for the No 4152LM and wiring connections to the

No, 4208 are provided m a subsequent secllon entitled “INSTALLATION

No. 4152LM AND WIRING TO No. 4208”.

Installer Code:

The installer programs the Installer Code initially as part of the program-

ming procedure (see “Programming the Security Control”) In this system,

the installer is considered to be user #1 The installer code permits re-entry

into the programming mode (unless *98 has been previously used to exit

the programming mode or if user #1 was not enabled in Address *52) and

also allows access to the normal functions of the system. During initial

programming, the installer also programs the Master security code into the

system

❑ ❑ ❑ ❑ Installer Code (User #l ), assigned during

programming.

Installer exits programming mode with:

*99 (allows re-entry into programming mode with installer code).

X98 (does not allow re-entry to programming mode unless system is

first powered down and then repowered). Installer code IS dis-

abled whemthis exlf is used

Master Security Code

The Master security code can be used to assign up to thirteen secondary

codes (to users #3-#1 5); it can also be used to remove all secondary

codes from the system (individually). The person to whom the Master

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 83 84

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista 4130XT