ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 29)

EXIT PROGRAM-

MING MODE:

ADVANCE TO FIELD:

PROGRAM FIELD:

ERASE FIELDS:

READ FIELD:

RESTORE FACTORY

PROGRAM SETTINGS

SPECIAL MESSAGES

*99 (always allows re-entry to programming

mode via Type 3 entry method above).

*98 (inhibits re-entry to programming mode via

Type 3 entry method),

Note When the programming mode is exited, a

1-minute set-up period must elapse before

the system can properly function

* + ADDRESS (e.g., 01, 10, 21, etc.).

* + ADDRESS, followed by data entries.

*+ ADDRESS+ * (only applies to Addresses 31

thru 34),

# + ADDRESS

*97 (see Factory Programming Table).

OC = OPEN CIRCUIT

(no communication between the Keypad and the

Control, most relevant to4137 or4157 Remote Console).

FC = FIELD CODE ERROR (program entry mistake, re-enter the data).

After powering up, READY will be displayed after approximately 7

seconds. Enter the programming mode by simultaneously depressing *

and # within 30 seconds. The System is factory-programmed with preset

values (see Table D) that can be altered via the programming instruc-

tions that follow the table.

FACTORY PRESET VALUES

Factory preset values serve two purposes:

● They can reduce programming time on the part of the installer if many

of the preset values shown in the table are accepted.

● They will permit an installer who is unfamiliar with this product to

quickly set up the system for bench test so that familiarity with the

operation of the system can be achieved in a shorter period of time.

The factory preset values are defined in the Table that follows:

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 29