ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 46)

FUNCTION

ADDRESS

POWER UP IN

●28

PREVIOUS STATE

QUICK ARM

●29

TOUCH-TONE OR

●3O

ROTARY DIAL

PABX ACCESS CODE*31

❑

COMMENTS: If selected (YES), on power-up the system w(II assume system status prior to power down. If not

selected (NO), the system w(II power up in disarmed state.

Enter O (NO) or 1 (YES),

When the system powers up armed, an alarm WIII occur 3 minutes after arming If a zone is faulted, When so

armed, reports closing as User #7 if open/close reporting for User #7 was enabled in Address *52.

❑

COMMENTS: Enables arming of the burglary system in any mode without use of a Security Code (just # key

depression followed by the command AWAY, STAY, INSTANT or MAXIMUM). When armed AWAY or MAXIMUM,

reports closing as User #7 (f open/close reporting for User #7 was enabled m Address *52,

Enter O (disabled) or 1 (enabled).

•1

COMMENTS: Permits selection of the type of dialing to be used.

Enter 1 for Touch-Tone, O for Rotary.

❑ 0 ❑ 0 ❑ 0 ❑ 0

COMMENTS: If not required, enter nothing and proceed to next address; otherwise, enter prefix needed to obtain

an outside Telco line. This field may be used alternatively to enter a prefix that can suppress the Telco’s call wait-

ing feature from interfering with outgoing transmission. This prefix is only useful if the Telco option to be able to

suppress call waiting has been obtained by your customer. The prefix to be used is 1170 if pulse dialing is being

used or *7O if TouchTone@ dialing is being used

Enter up to 4 digits, Each digit requires a 2-digit entrj so as to allow entry of hexadecimal digits (B-F) Use the fol-

lowing chart to determine the entry for each dlglt. Only enter digits required Do not fill unused spaces. Erase the

field by entering *31*.

-—-

—

—. -.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 46