ADEMCO Vista 4130XT Manual de instrucciones Pagina 50

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 84
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 49
FUNCTION
DIAL TONE
DETECTION
ADDRESS
*43
RING DETECTION
*44
COUNT
PRIMARY ACK WAIT *45
PRIMARY
*46
TRANSMISSION
FORMAT
SECONDARY ACK
*47
WAIT
COMMENTS: Determines whether true dial tone detection is used, or whether just delay before dialing (same as
programmed in Address *42) is used. The latter may be necessary in high-noise environment Telco networks
where noise can be confused with dial tone and premature dialing results.
Enter 1 (Dial Tone Detection) or O (Dial Tone Detection disable),
n
COMMENTS: Only applicable if central station initiated downloading will be used. Enter 00 to disable ring detec-
tion. Enter 01-14 for ring counts of 1-14. Enter 15 to select mode that gets around telephone answenng machines
connected to the same phone line. In the latter mode, the system upon hearing one ring followed by nothing, will
not answer but will ready itself to pick up the next incoming call received within the next 30 seconds on the first
ring (the downloader calling again).
COMMENTS: Central Station receiver “Acknowledge” wait time for primary phone number.
Enter O (30 seconds) or
1 (60 seconds).
•1
COMMENTS: Permits selection between Ademco Low Speed format, SESCOA/Radlon!cs, or Ademco High Speed
format.
Enter O (Ademco Low Speed) or
1 (SESCOA/Radionics), or 2 [Ademco High Speed - Traditional for up to t4 (all
20 if non-unique reporting is acceptable) zones plus duress and 4+2 DTMF for all 21 zones].
Note If Traditional Ademco High Speed reporting is selected, the Non-Alarm reports desired must be selected in
Addresses *40, *67 and *68 and the alarm reports desired must be selected in Addresses *65 and *66
(Any non-zero code may be used).
COMMENTS: Central Station receiver “Acknowledge” wait time for secondary phone number.
Enter O (30 seconds) or 1 (60 seconds).
Vista de pagina 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 83 84

Comentarios a estos manuales

Sin comentarios