ADEMCO Vista 4130XT Manual de instrucciones descargar pdf (Pagina 74)

“FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT”

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following

statement for

your information:

This equipment generates and uses radio frequency energy and

if not installed and used properly, that is, in strict accordance with

the manufacturer’s instructions may cause interference to radio and television reception. It has been type tested and found to

comply with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules,

which are designed to provide reasonable protection against such interference in a residential installation. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

● If using an indoor antenna, have a quality outdoor antenna installed.

● Reorient the receiving antenna until interference is reduced or eliminated

● Move the receiver away from the control/communicator.

● Move the antenna leads away from any wire runs to the control/communicator.

● plug the Control/Communicator into a different outlet so that it and the receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.

The

user may find the following booklet prepared by the Federal Communications Commission helpful:

“HOW to Identify and Resolve Radio-TV Interference Problems.”

This booklet is available from the U.S. Government Printing Office, Washington, DC 20402 Stock No. 004-000-00345-4.

IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS

In the event of terephone operational problems, disconnect the con-

Iines, the control/communicator has a problem and should be

trol/communicator by removing the plug from the RJ31X/RJ32X jack.

returned for repair.

We recommend that the installer demonstrate disconnecting the

If upon disconnection of the control/communicator, there is still a

phones on Installation of the system. Do not disconnect the phone

“problem on your line, notify the telephone company that they have a

connection inside the control/communicator. Doing so will result in

the loss of the phone fines. If the regular phone works correctly after

problem and request prompt repair service. The user may not under

any circumstances (in or out of warranty) attempt any service or

the control/communicator has been disconnected from the phone

repairs on the system. It must be returned to the factory or an

authorized service agency for all repairs.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 83 84

Sin comentarios

ADEMCO Vista 4130XT Manual de instrucciones Pagina 74