ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 9)

ZONE 6: Ths zone maybe programmed to sewe as a tamper loop for the C-COM c;ibinet

ALTERNATE TAMPER and for the Ademco AB12 grade A burglary bell box. For Grade A Burglary

FUNCTION

installations, field Y17 must be programmed to “l” to enab[e this function and

zone 6 should be assigned a day/night burglary res~nse (zone type

05). The

panel will initiate a day trouble/night alarm when an open or short circuit is

detected in this zone or when an earth ground fauk caused by tampering with the

AB12 burglary bell box is detected. See the BELL CIRCUIT OUTPUTS setion for

AB12 bell wiring information.

ZONE 7: This zone may be programmed to sewe as a keyswitch input. See the REMOTE

ALTERNATE KEYSWITCH section for keyswitch programming, wiring and operating

KEYSWITCH FUNCTION

information.

ZONE 8

This zone has the added capatifify of supporting 2-wire latching type glass break

TWO WfRE GLASS detectors. Use detedors which are wmpafible with the ratings fisted below. The

BREAK DETECTORS second ent~ of an OFF sequewe wilf interrupt zone power to allow detedors to

reset followiW an alarm.

Compatible Z-wire Glass Break Detectors

Standby Voftage: 5VDC - 14VDC

Standby Resistance: Greater than 20k ohms (equivalent resistance ~ofall

detectors in parallel)

Alarm Resistance: Less than 1.lk ohms (see note below)

Alarm Current 2 MA -10 MA

Reset Tree: Less than 6 semnds

The IEl 735L series detectors have been tested and found to be compatible?with

these ratings. Up to 50 IEI 735L deteaors, mnnected in parallel, maybe used

(the alarm current provided by this zone is sufficient to support operation 0[ only

one detector in alarmed state). Follow the manufacturers recommendatiot~s on

proper detector installation.

NOTES:

. Detectors which exceed 1.1k ohms in alarm, but maintain a voltage drop in

alarm of less than 3.8 votfs can also W used.

. Use of N.O. or N.C. contatis on the same zone may prevent proper glass

break detector operation.

-9-

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 73 74

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 9