ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 36)

, .~

KEYPAD FUNCTIONS

GENERAL

Note that if QUICK ARM is enabled (field ‘29), the [#] key can be pressed instead

INFORMATION

of entering the secutity code, for any of the arming procedures (Away, Stan

Instant, Maximum, etc.).

The keypad allows the user to enter commands to silence/reset alarms, to arm

and disarm the burgla~ poflion of the system, and to perform other system

functions, such as bypassing zones, view messages from the central station and

display zone descriptors. Zone andsystem conditions (alarm, fire supewisoy,

trouble, bypass) are displayed in the Display Window.

When an alarm occurs, console sounding and external sounding will occur, and

the zone(s) in alarm will be displayed on the console. Pressing any key will

silence the console sounder for 10 seconds. Entering any security code will

disarm the burgla~ system (if it was armed) and will silence both console and

external sounders. When a fire alarm is silenced, consoles will display the

message FIRE BELLS SILENCED to indicate that a fire alarm condition may still

be present. Any zones that were in an alarm condition will be displayed (memov

of alarm). To clear ths display and to reset 2-wire devices such as glass break and

smoke detectors, simply reenter the security code andpress the OFFkey. Note

that the display will clear only if the zone alarm condition is no longer present.

The consoles also feature ctime annunciation, and 3 panic key pairs (for silent,

audible, fire or personal emergency alarms) which can notify the central station of

analarm condition, ifthat sewice is connected.

ARMING FUNCTIONS

The following is a brief list of system commands. For detailed information

concerning system functions, refer to the User’s Manual.

Disarmed Not Ready Before arming, the system must be in the READY

condition (all zones must be intact). If the “NOT READY message appears, press

the READY ~] key to display faulted zones.

Arming Away Enter code + AWAY [2].

Arming Stay

Enter code + STAY [3].

Arming Instant Enter code + INSTANT [7].

Arming Maximum Enter code + MAXIMUM [4].

Disarming

Enter code + OFF [1].

Bypassing Zones

Enter code + BYPASS [6] + zone number. To

automatically bypass all faulted zones, use “Quick

Bypass” method: Enter code + BYPASS+ [#].

Chime Mode

Enter code + CHIME [9]. To turn chime mode off, enter

mde + CHIME again.

-36-

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console