ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 12)

SYSTEM ZONES (Zones 70- 99)

GENERAL

Aside from the 64 hardwire and polfing loop sensor zones, the 5140XM provides

INFORMATION a number of additional zones which are dedicated to monitoring various aspects

of system behavior. These system zones are listed below. The “system zor “

number appears in the console display window when a fault contition associati

with this zone is detected. The zone types programmed in field 3’10 (for zones

70-75) and field ’05 (for zones 95-99) determine the panel’s response to “system

zone” faults.

Zone #70: Bell Output 1: Monitors bell 1 outpu~s supewision status (if enabled

at installation time). See the BELL CIRCUIT OUTPUTS section for

more information.

Zone #71: Bell Output 2: Monitors bell 2 outpu~s supervision status ct enabled

at installation time). See the BELL CIRCUIT OUTPUTS section for

more information.

Zone #72: Earth Ground: Monitors the panel’s field wiring to determine if an

eatih ground fault exists. Ttis zone’s default type is

set to [19] (24

hour trouble) to provide a trouble response to earth ground faults.

When the panel detects an earth ground fault caused by tampering

with (i.e.: drilling through) the Ademco AB12 grade A burglary bell

box, it overrides the zone 72 fault response and instead ttiggers a

zone 6 alarm (if enabled in field 3’1 7).

Zone #73: J2 Input: Monitors the status of Input 1 on the main PCB J2 header.

Input 1 can be used to monitor the “Xmit Okay” signal from the

7620ULF LORRA. See the TRIGGER OUTPUTS section for more

information.

Zone #74 Dialer Line 1: Monitors the supervision status of the main dialer

output (K enabled at installation time). See the DIALER OUTPUTS

section for more information.

Zone #75: Dialer Line 2: Monitors the supe~ision status of the optional

5140DLM back-up dialer module’s output (if installed/enabled

installation time). See the DIALER OUTPUTS section for rob_,

information.

Zone #76: Auxiliary Relay: Assigned to the built-in auxiliary relay for the

purposes of allowing the operation of this relay to be bypassed.

Wnce the auxilia~ relay is not supervised, this zone does not monitor

anytting and cannot be assigned a zone type.

Zone #77 LORRA Triggers: Assigned to the LORRA triggers on the main PCB

J2 header for the purposes of allowing the operation of these

triggers to be bypassed. Since the LORRA triggers are not

supervised, this zone does not monitor an~hing and cannot be

assigned a zone type.

Zone #95: Keypad Panic: Activated by simultaneous depression of the console

~] and [1] keys. See the KEYPAD FUNCTIONS section for more

information.

Zone #96: Keypad Panic: Activated by simultaneous depression of the console

[#] and [3] keys. See the KEYPAD FUNCTIONS section for more

information,

Zone #97: Polling Loop Short: Monitors the polbng loop wiring

for short circuit

faults, See the POLLING

LOOP section for more information.

Zone #99: Keypad Panic: Activated by simultaneous depression of the console

~] and [#] keys. See the KEYPAD FUNCTIONS section for more

information.

-12-

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console