ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 34)

To ADD a Master,

Manager or Operator

cod=

To CHANGE a Master,

Manager or Operator

code:

To DELETE a Master,

Manager or Operator

code:

To WEW User

Authori& Level

Enter Installer Code + [8] + new User # + new Usets code

(ex. 5140+ [8]+ 02 + 1234)

Console will prompt for Authority level. Enter the desired level number from the

table above

Console will then prompt for Open/Close reporting optiont. Press O (NO) or “Y’

(YES). The console will display the user ID number and associated authority level

when the new code has been successfully entered.

Enter Installer code + [8]+ User number+ new code for that user

The system will detect that the user number is already assigned and will prompt if

this is a new user. Press O (NO). The system will then confirm that the change is

allowed based on authorization level. If the user number is the same as the

Installer’s, the system will prompt for the new code to be reentered. This prevents

accidentally changing a high level code.

Enter Installer code + [8] + User number+ Installer code

The system will prompt if this code should be deleted. Press O (NO) or 1 (YES). [f

yes, that users code will be removed and the authority level and all other

information about that user will be deleted. Note that a user can only be deleted

by a user with a higher a~thority level. A user cannot delete himseM.

TO EXIT THE USER CODE ENTRY MODE, either press [*] or [#], or

don’t press any key for 10 seconds.

Once a user code has been programmed, its associated user ID number and

authority level can be viewed by enteting that user’s code + ~] + ~].

User numbers must be entered as 2-digit entries. Single digit user numbers

must, therefore, always be preceded by a “V (example, 03, 04, 05, etc.). Make

sure the end user understands this requirement. Tempora~ codes are entered

as 4-dfgit numbers.

IMPORTANT!: Unless Ademco Contact ID repofiing is used, only user code,

#1 #15 can uniquely report to the central station using the communicafionw

formats provided. Users #16 - #99 will repofl as User #15, if enabled for

open/close reporting, for the other repoding formats.

IMPORTANT!: During user code ent~, normal key depressions at other

consoles will be ignored. However, panic key depression will cause an alarm and

terminate user entry.

t OP”EN/CLOSE REPORTING NOTE: When adding a user, the SyStem will

only prompt for OpetiClose reprt capabilfiy if the user is being added by the

Installer. When a Master or Manager adds a new user, the new users OpeWCbse

re~rfing enable will be the same as that of the Master or Manager adding the

user. If Open/Close reports are required to be selectable by the Master or

Manager, the Installer should assign two Master or Manager user codes: one with

Open/Close repofling enabled, and one without Open/Close repoting.

–34-

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console