ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 14)

POWRING AND The 5140XM suppods, independent of auxiliary power considerations, up to

WIRING

sixteen 5137AD/51 37ADR mnsoles. The 5140XM can supply up to 1 amp of

euxitiaw standby power for consoles, pelting loop devices, motion detectors, 4-

wire smke detecfom, etc. (the maximum auxiliary standby bad that mn be drawn

is hinted by the capaciy of the backup battery

used. A 1 amp load requires a t

AH battery. See the POWERING THE SYSTEM section for more informat~).

Provided that the maximum permissible standby load is not exceeded, up to 11

consoles (at 90mA per wnsole) can be powered from the pane~s auxifiary power

1 and auxihary power 2 outputs.

Keep this in mind when adding consoles so that

the pane~s power supply is not overloaded resulting in a battery which does not

properly charge.

If the pane~s maximum permissible standby load is exceeded, then additional

mnsoles an~or other auxilia~ devices can be powered from a separate UL

Commercial Listed Wwer supply. The Alarm-Saf model AS/PS5-BFS-l 2-UL

Commercial Fire Listed supply can be used to power additional consoles and/or

other auxiliaw fire davices. The dia~ram below shows how to make connections

to the

Alarm

-Saf power supply. -

R,ure 2. MM -SW POWER SUPPLY CONNE~ON DIAGWM

Supplementary consoles may be wired to a single wire run or individual consoles

may be mnnacfed to separate wire

rims. The maximum wire run length from the

panel

to a mnsole whwh is homrun back to the panel must not exceed:

CONSOLE WIRE RUN

. ------ .“

LtNU I nZ

,#,6*1 gaugewn)

If more than one console is wired to a single

run, then the a~ve maximum lengths must

divided by the number of consoles on

the run (i.e. the maximum length would be

225 feet if two consoles are wired on a #22

NOTE: The length of all wire runs mmbined must not exceed 2000 feet when

unshielded quad mnducfor cable is used (1000 feet ff shielded cable is used.)

ADDRESSABLE

The 5137AD and 5137ADR mnwles are addressable devices. They have a built-

CONSOLE DIP SWITCH

in DIP switch which is used to select their operating address. Each console used

SETTINGS

must be assigned a unique address for proper system operation. Refer 10 the

figure and table below to set this DIP swtch. The panel can be programmed to tell

it what sounding options should be used for each console (refer to DEVICE

PROGRAMMING in the PROGRAMMING THE SYSTEM section for more

information). The pane~s standard factory default enables all console addresses

and sets each console for no sounder suppression. You only need to use the

Device Programming Mode at initial installation if you desire to change ‘he

sounder options for one or more consoles.

-,,

NOTE: Some versions of the 5137AD/5137ADR mnsoles have a sixth DIP

swich. Make sure that fhe sixth swtch is in the DOWN psifion.

-14–

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console