ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 28)

FLUSH MOUNTING 1.

MTH TRIM RING KIT

(5137TRK) ~

Cut out a 4-3/4 high by W wide opening in the wall between studs, no less

than 1-1/2 from ether stud. Use the template provided to mark the cut-ut.

Insert the four l-1/Z bW #6 screws through the mounting holes in the Trim

Ring and then attach the four metal securing clips, as shown in the diag~ I.

Use only two or three turns of each screw, allowing the metal chps to ~g

freely. The clips must mt protmde beyond the sides of the Trim Ring or you

will Mt be able to install the Trim Ring into the wt-out in the next step.

Install the trim ring into the opening in the wall with the hinge clasps to the

right. Mating sure tha trim ring is straght, tighten each clip screw, makiW ~re

that the attached chp sfides down info is guide track.

Install the Console as follows: Engage the hinge clasps on the trim ring with

the notches located in the back (fght-hand side) of the Console’s front panel.

Swing the left side of the panel toward the trim ring (the panel will pivot on the

hinge clasps), ati press firmly until the panel “snaps” closed.

Use tha panel securing screw (supplied with the Console) to secure the left

side of the panel.

figure 17. FLUSH MOUNTING CONSOLES

ADJUSTING THE

Insert the end of the small, key-shaped tool (supplied) into the small hole to the

ALPHA CONSOLE LCD left of the console tisplay window (the adjustment screw is recessed in this ~le).

WEWNG ANGLE

Turn the adjustment screw to the left or right until optimum viewing is achieved.

Be sure to take the heiaht of the users into account when maMnrr this

-28–

$,,...,..

k-%?

Fg”re t 8. ADJUSTING VIEW ANGLE

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 73 74

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 28