ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 58)

X. REGULATORY AGENCY REQUIREMENTS

NOTE 1: Set field 3’82 to “O” to disable burglary faatures H

burglary protetiion

will not be installed (disables

AWAY, STAY, MAXIMUM, INSTANT, TEST and

CHIME key fundions).

NOE2 Thasdb”ns in brackets []pmvide more detailed

wiring and pr~ramming instrutiions.

NOK& For fire only or wmtination fire and burglary

installations, AC loss reports must retransmitted

to the central station batween 6 & 12 hours after

bss of AC pwer (field “19=2), and neither bell 1 or

bll 2 should ring an alarm 4 hours after bss of AC

power (fields ’18, 3.58=0). For burglary only

installations, AC loss must be transmitted less

than 6 hours after loss of power (field “19=0 or 1),

and etiher bll 1 or bell 2 should ring an alarm 4

hours after bs of pwer (fieti “18 or 3’58=1 ).

UL864/NFPA72A

Local Fire

CO flfigUrE at least one ball output for supewisbn and

wire polatized fire alarm indiato~ to it. Program this bell

for pulsed operation when burglary protection will be

installad [BELL OUTPUTS].

UL864/NFPA71

Central Station

. You may use a 7620ULF or 7920SE LORRAS

abne, tha

main dialer wkh the LORRA, or the main dialer with tha

5140DLM Ba&up Dialer Mdule. Refer to the LORRA

Installation Instrutiions for more detaiiad informatbn.

. When using the LORRA, mnneti its channel inputs to

the 5140XMS Fire Alarm, Fire Supewisory (if installad)

and Trouble Triggers. Also connad its XMIT OKAY

output to the 5140XWS J2/hr put 1 input. Program

J31nput 1 zona 73 for a 24 hour trouble response (type

19) to radb fauhs (ace TRIGGER OUTPUTS s~ion),

. When the main dialer is usad, enable it (field 3“30) and

rnnnea it to a telephone hne. Assign a 24 hour trouble

ras~rrse (type 19) to zone 74 to enable main dialer

supervision (field 3“1 O) (see DIALER OUTPUTS

sed”on). The 5140XM will advate the trouble trgger to

trip the LORRA If uaad) when tha main dialer is fauhad.

. When the 5140DLM Badup Dialer Modula is used, in~afl

h on tha 5140XMS PC board shield. Enable it (fieti 3“30)

and rnnned it to a separate telephone fine. Assign a 24

hour trouble response (type 19) to zone 75 to anable

backup dialer supervision (field 3.10) (see DIALER

OUTPUTS sedtin).

. When a dialer is used, program k to send fire alarm, firs

supewisory, trouble, AC loss and mmmunicator test

re~rts. Field .27 must be set to “024” (or less) so that

test reports are sent at least once eve~ 24 hours.

. if a sewndary phone number is programmed (field ’34)

then tha maximum number of dialer retries (field 3.21)

must ba restrided to 3, 4 or 5.

UL609

Grade A Local Mercantile Premises/Local

Mercantile Safe

and Vault

Confiiure one bell output for no supawision and wire a“

AB12 grade A beilhx to ti. Bell wires must be run in

mrrduit. Program ttis bell for steady alarm sounding, 16

or more minute timeout, and for tin formation of ar-ming

ding [BELL OUTPUTS].

. Attach a door tamper- switch (supphed) to the 5140XM

back-box. For safe and vault installations. a shock

sensor (not’supplied) must also be attachad tO the baA-

hx [MOUNTING THE CABINEm.

. Wir~ tha bell bx and 5140XM ~abinet tamper swkchas

(and shock sensor, if used) to zone 6. Select the zone 6

aiternate tamper furrtiion (field T 17=1) and assign zone

6 a day/night response.

. Entry dalays must not exceed 45 sewnds and exit

delays must not ex-ed 60 semnds.

. If 4190WH RPMs are used, set field .24 to “0” to enabl,-

tampar detedion. Saa the POLLING LOOP sedion for

notes regarding the usa of RPMs for montioting fire and

burglary sensors.

UL 365 Pollee

Station Connected Burglar Alarm

Follow the inafruaions for UL 609 local installations

For Grade A Service:

. You may use the main dialer alone, the main dialer with

the 5140DLM Back-up dialer module, the 7620ULF (or

772o) LORM alone or tha 346 plar~ reversal relay.

. When using the main dialer a[ona, program it to send

burglay alarm, low battery and communicator test

rapfis. Held ’27 must be set to ‘024” (or less) so that

test reports are sant at least onca every 24 hours.

. Whan using tha main dialer with the 5140DLM back-up

dialer mdule, assign a 24 hour trouble response (type

19) to zones 74 and 75 (field V1 O) to enable su~wision

for kth dialers. Proaram tha dialer to send burolaw

alarm, troubla and I;w battery reports (see DIA”LER

OUTPUTS =tion).

. When the 7620ULF (or 772o) LORRA or 346 polarity

reversal relay is used, connect it to the 5140XMS

burglary/audible panic atarm trigger (see TRIGGER

OUTPUTS setion).

For Grade AA Service:

. You may use a 7920SE LORRA alone or a 445 high line

security transmittal.

. Conned the 7920SE LORRA or the 445 transmitter to

Ihe 5140XMS burglary/audible panic alarm trigger (se

TRIGGER OUTPUTS sdion).

UL611/UL 1610 Cantral Station Burglar Alarm

. Follow the instructions for UL 609 local installations

For Grade A Sawice:

. ~yR~~ use the main dialer with the 7620ULF (or 772o)

. tinned the 7620ULPS inout channels to the 5140xMs

burgIary/audible panic alarm and trouble ttiggers. Also

connect the 7620ULPS ‘XMIT OK” outgut to the

5140XMS J21nput 1 input. Program J2/lnpui 1 zone 73

for a 24 hour trouble raspnse (type 19) to radio faults

(sac TRI=ER OUWUTS s~tion).

. Enable the main dialer (field 3.30) and conned it to as

telaphone line. Assign a 24 hour trouble res~nse (type

19) to zone 74 to enable main dialer supewision (field

3.1 0). Tha 5140XM will activate the trouble triaaer to ttio

the 7620ULF when the main dialer is fauked (s;; DIALER

OUTPUTS section).

. Program the dialer to send burglary alarm, trouble,

opening/cbsing and low battery re~tis.

For Grade AA Sawi~:

. Follow the instructions for Grade A installation excapt

use tha 7920SE in place of the 7620ULF.

New York City Requirements

New York City Fire Department

Drohibits commercial

combination {ire/burglary panel;. When using the

5140XM for fire prote~ion, burglary prot~tion cannot&

implemented.

-58-

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 58

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console