ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 7)

Type 09

Supewiaed Fire (No

Verification)

,-.

Type 10

itierlor w/Delay

Type 16

Fire Mth Verification

Type 17

Fire Waterflow

Ty~ 18

Fire Supewiaory

Type 19

24 Hour Trouble

Used for zones containing smke detectors (when smoke alarm verification is not

desired), or containing heat detectors, pull stations, etc. An open in this

zonf? will

intiate a trouble

sig~l. A s~ti in this zone will mtiate afire alarm.

This zone type gives entry delay (usiW the programmed entry time), if tri[]ped

when the panel is amed in the Away rode. This zone type is also active

dlJfing

maximum mode, but no delay is provided (alarms occur immediately

if zone is

tripped). This zone type Is bypassed when the panel Is srmed in the

Stay or fnstant modes. Delay begins whenever sensors in this zone are

violated, regardless of whether or not an entry/exif delay zone was tripped first.

Used when smke alarm verification Is desired on hardwire and polling loop zones

mnfaining only 2-wire or 4-wire smoke detedors. An open will initiate a trc,uble

response and a short initiates a fire alarm res~nse, Initial short detection causes

6 second smoke detector power reset. Subsequent short detection wit~n 90

smnds of reset causes fire alarm.

An open in this zone causes a trouble response. Shorts which remain present for

bnger than the programmable time delay cause a fire alarm response,

This type is assigned to a zone haviW sensors which monitor fire sprinkler

systems ~.e. PIV switches, etc.). An own in this zone causes a trouble. Shofls

which remain present longer than the programmable time delay cause a

supervisory res~nse. Supervisory response will not activate a bell output,

An open or shoti in this zone causes a trouble response. No external alarm

sounders are actuated.

-.7-

1 2 3 4 5 6 7 8 9 10 11 12 ... 73 74

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 7