ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 35)

Ml\STERfMANAGER As shipped from the factory, there are no master or manager codes pre-

~SODES (Authority

programmed. The installer must program at least one master code during initial

Levels 1/2) installation.

Generally speating, the Master Code is intended to be known and used by the

building owner. Themanager code isintended to be known andused by the

building superintendent, the building security officer or the like. These codes

allow full control over burglay system operation. They can be used to program

Iowerlevel codes on arias needed basis, for use by those who need limited

and/or temporary control over system operation such assupewisors, employees,

cleaning personnel, tenants, etc. To add, change or delete user codes, follow

the procedure described in the INSTALLER CODE paragraph, substituting

master or manager code for the installer code. Note that a master user can

program codes for a manager or lower level user, and cannot change a master

level code. A Manager can program codes foranoperator ortorduress, and

cannot change a manager level code.,

Master Codes and all Iower level codes can be used interchangeably when

peflorming system functions (a system armed with an operator’s code can be

disarmed with the Master Code), with the exception of the Operator C Code

described later in this section.

OPEN/CLOSE REPORTING: Note that open/close reporting enables for

added users are the same as that of the master or manager adding the new user.

OPERATOR CODES

Operators can arm and disarm the system to the authority assigned, but cannot

(Autllority Levels 3-5)

addormodify any user. lfOperator C isselected, that operator’s code cannot be

used to disarm the system urrless the system was armed .with that c~de. This

code is usually assigned to persons who may have the need to arm and disarm

the system at specific times only.

OPERATOR LEVELS OF AUTHORIW

Level Title

Functions Permitted

3 Operator A

Arm. Disarm, Bypass

4 Operator B Arm, Disarm

5 Operator C

Arm, Dsarm only if armed with

same mde

DURESS CODE

The duress code is a means of sending a silent alarm to a central monitoring

(liuthority Level 6) station if the user is being torced to disarm (or arm) the system under threat. This

feature is only useful if the system is connected to a central station using the built-

in dialer or a LORRA. Duress has its own unique report when digitally

communicated, but issignaled onthesame trigger that signals silent panic when

communicated viathe LORRA. When used, thesystem will disarm (or arm), but

will also send asilent alarm tothecentral sfation. There will benoindicafion at the

console that an alarm was sent.

-35-

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console