ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 13)

III. PERIPHEWL DEVICES

F.,

GENERAL

INFORMATION

TWO CONSOLE PORTS

REMOTE CONSOLES

The 5140XM panel interfaces to 5137AD (gray bezel) and 5137ADR (red bezel)

alpha custom LCD consoles. These consoles provide visual and audible

indication of system status and allow the user to enter system operating

commands. These consoles provide the following features:

. 2-fine, 32 character(16 characters per hne) alpha numeric LCD display wtich

provides a programmable “Enghsh Language” description for each zone.

. 12 key telephone style keypad. The keys are back-~i.

. Built-in sounder which provides audible indications of alarm, fire supervisory

and trouble conditions.

. Choice of gray or red front bezel.

NOTE: Many municipa~ties require that fire system annunciators be red in color,

Check wlh the authodfy having jurisdiction before choosing a console color for

your installation.

. 90 mA current draw.

The 5140XM provides 2 console interface Pfls. Port 1 uses terminals 11.14 on

the main PCB terminal block and port 2 usee pins 1,4,5,, 7 on the main PCB J4

connector as indicated below. The wrt 2 ~wer/data wires are elecfricallv isolated

from (i.e. not affected by open, short or earth ground faults on) wrt 1 ~wer/data

wires. Note that the 4142TR nine wire cable (1 cable suppfied) is used to m:ike

connections to the J4 connector.

Port 1

terminal 11: aux power#l output (to mnaole red wire)

terminal 12: ground (to mnsole black wire)

terminal 13: data in 1 (to console green wire)

terminal 14: data out 1 (to console yellow wire)

Port 2

J4/pin 1: ground (to console black wire)

J4/pin 4: data in 2 (to mnsole green wire)

J4/pin 5: aux power W output (to console red wire)

J4/pin 7: data out 2 (to console yellow wire)

When only 1 console will be used in the installation, this console must be

mounted on or near the cahnet (see the MOUNTING THE CONSOLES section)

and may be wired to either wrt. When more than 1 console will b installed, the

“main” console must be mounted on or near the caMnet and must be wired to

Pod 2. The “suppleme~ary” consoles can be mounted where desired and must

be wired to Port 1. The “main” console will continue to function even when

wiring

faults prevent the “supplemental” consolee from operating properly, Note that

the panel can detect earth ground faults on Port 1 and 2 wiring but does not

supewise this wiring

for open and short circuit faults.

- 1:3-

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console