ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 26)

IV. MOUNTING

MOUNTING THE

CABINET

MOUNTING THE

CABINET LOCK

ADVISORY

-26–

AND POWERING THE SYSTEM

Mount the cabinet to a sturdy wall using fasteners or anchors (not supp~ed) ir ~

clean, dry area w~ch is ~t readily accessible to the general pubtic. The bac~,

the cabinet has 4 holes for this pu~se. Installations which are intended to

provide hsted brgla~ sewke have special attack resistance considerations for

mounting the cabinet which are described below.

Grade A Mercantile Premises Llstlng

. The panel door must be supervised, Mount the clip-on tamper switch

(supplied) to the cabine~s rghf side wall as shown in the diagram below and

wire it to zone 6.

. Use a bell with a tamper protected housing such as the Ademco AB12. The

bell busing’s tam~r switch and inner tamper linings must also be wired to

zone 6.

. Program zone 6 for day trouble/night alarm (type 5, field ‘02)) resWnse and

enable the zone 6 akernate tamer function (field 3“1 7).

. All wiring between the ball ati panel must be run in conduit. Remaining wires

do not need to be run in conduit,

. All wiring which is wt mn in conduit must exit from the knock-out openi~s on

the bottom or back of the cabinet.

. All unused knockouts must be plugged using the disc plugs and carriage hhs,

supphed, as indicated in the diagram below

. Fasten the cabinet door to the cabinet backhx using the 16 one inch long

phitips heads screws (supptied) after all wiring, programming and checkout

procedures have been mmpleted

Grade A Mercantile Safe and Vault Listing

. Follow the instructions given above for Mercantile Premises fisfirrg, except as

noted below.

. Mount a shock sensor such as Sentrol No. 5402 to the pane~s backbox. Fc’’+,v

the manufacfurets instructions on proper sensor mounting. This sensor “._,.,t

also be wired to zone 6.

Insert the key into the bck. Position the lock in the hole mating certain that

the latch will make contact with the latch bracket when the door is closed.

While holdng the Iwk steady, insefl the retainer chp into the retainer slots.

Postiin ckp as illustrated in the diagram to facilitate easy remval.

Make certain that the PCB mounting screws are reasonably tight to insure that

there is a good ground connection between the PC board and the cabinet. Also,

dress field wiring away from the microprocessor (center) section of the PC board.

The cabinet provides 2 hops on ifs left and right sidewalls for anchoring field

wiring using tie wraps. These steps are important to minimizing the risk of panel

RF interference with television reception.

‘+D KNOCKO~/,,&,,,,,:,,:L:R:F -

TO ,,”. A. “.”,,0 KNOCKOUT O, E.ING, R,..., KNOCKO”T AN.

,.s,,.,. ,.,. OF 0,s. ,,”.s AND A CA..,.., 80,,.s SHOWN

0,,.,..

,,”.

,.,s .“. AL, REM,.,..

K.ocK.om w,,,,,..” H,.,

>’ - c’””’’”“o”

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console