ADEMCO Alpha Vista Console Manual de usuario descargar pdf (Pagina 21)

IWMOTE =YSWITCH An optional UL Listed remote keyswitch ~n be used for remote armin@disarmiW

OPE-TIONMIRING of the burglary portion of the system and for remotely silencing alarms. If used,

program fieti “15 mu~ be set to “1- or “2” to select a keyswifch operating mode.

Zone 7 must be assigned a non-zero response type. Also, fie~ 3’20 must b set

to ‘1” t it is desired to use J20UT 1,5 to o~rate keyswifch ARMED a~ RFADY

LEDs (if keyswitch provides LEDs). The keyswitc~s normally open momentary

switch ad LEDs (it used) must be connected to zone 7 and to J20UT 1,5

respectively as shown in the diagram bbw. An optional cbsed circuit tamper

switch (ex. Adem ~. 112) can be wired in series wth zone 7 so that keyswifch

operation will be dbsblad when the swfichplate is remved from the wall.

The 5140XM allows 2 modes of keyswitch operation. When field ’15 is set to ‘1-,

the keyswtich operates as follows:

With System Disarmed and No Alarms Present:

A momentary short across zone 7 will arm the system in the AWAY mode, and a

short held for more than 3 seconds will arm the system in the STAY rode. A

subsequent short will disarm the system. The keyswitch LEDs will indicate that

the system has armed (see table below). NOTE: FauRed zones must ei~r be

comecfed or bypassed before the system will arm.

.,-

With Alarms Present:

A momenta~ skrt across zone 7 will silence alarm bell and mnsole sounds, ati

will disarm the system if t was armed. The keyswfich LEDs will provtie a memory

of alarm indication (see table bebw). A subsequent short across zone 7 will clear

the alarm memory indkkation and reset 2-wire smoke am glass break detectors (f

used).

When field ’15 is set to “2”, the keyswitch operates as follows A mmenfary short

across zone 7 will silence slam ball sounds ~.e. turn off Bell 1, Bell 2 and aux relay

t programmed for alarms) only ti a fire alarm is present. Outputs remain siltmcad

until a code + OFF is entered to reset alarms and clear alarm displays. A

momentary short has no effect if there are no fire alarms present. Thb mode is

intended to be used where it is desired to provide the fire deparfmenu with

keyswitch silence capsbi~iy wtihout compromising the burglary system’s semrify.

LED indications are defined

as follows:

GREEN RED

MWING

OFF OFF

DBARMED & NOT R~DY

m OFF DISARMED & R~DY

OFF

ON STEADY ARMED AWAY

OFF SLOW FLASH

ARMED STAY

OFF RAPID FLASH MM MENRY

NOTE: Open/close reporting for keyswitch is enabled in field ’40, and the keyswfich

reptis

as user O

figure 8. KWSW~CH WIRING

If “w W5.16 .75,. .1. or .2. for dad kwstich retie

m, field 3.20 to ,,t. to .“*I. ED d“w (KLED“~)

J2 CONNECTOR

–21-

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 73 74

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console