ADEMCO Vista-128B PLUS Especificaciones descargar pdf (Pagina 70)

VISTA-128BP/VISTA-250BP Installation and Setup Guide

5-10

FIELD

TITLE and DATA ENTRIES EXPLANATION

1*33

TouchTone with Rotary Backup

= disable

= enable

If enabled, the system reverts to rotary dialing if communicator is not

successful in dialing using TouchTone DTMF on first attempt.

1*34

Communicator Split Reporting

= Split Reporting disabled

= Alarm, Alarm Restore, and Cancel

reports to primary, all others to secondary

= Open/Close and Test reports to

secondary, all other reports to primary

Select the type of split reporting for system communication.

NOTE:

See *51 for split/dual reporting combinations.

1*35

Access Control Dialer Enables

= disable

= enable

There are six entries for this field as follows: Trace, Trouble, Not Used,

Bypass, System, Alarm.

If Trace is enabled, access grant/denial events sent to the central station.

For the other events, if enabled, a report is sent to the central station.

1*42

Call Waiting Defeat

= disable

= enable

If enabled, the system defeats Call Waiting on the first outgoing call

attempt to both the primary and secondary numbers.

NOTES:

After the panel's initial call to report the alarm, the panel may attempt to

make an additional call, perhaps for a cancel or a zone restoral. If Call

Waiting is not defeated, an operator at the central station attempting to

contact the premises (to verify whether the alarm is valid) hears the

phone ringing indefinitely and must to dispatch on the call.

DO NOT enable this feature unless Call Waiting is being used.

1*43

Permanent Keypad Display

Backlighting (partition-specific)

= disable

= enable

If enabled, backlighting for the keypad display remains on at all times.

Otherwise the backlighting comes on when a key is pressed.

NOTE:

When a key is pressed, display backlighting turns on for

all

keypads in that partition.

1*44

Wireless Keypad Tamper Detect

= disable

= enable

If enabled, when more than 40 key depressions are received without a

valid sequence (arm, disarm, etc.), the control panel disables the wireless

keypad. The inhibit is removed once a valid key sequence is received from

a wired keypad.

1*45

Exit Delay Sounding (partition-

specific)

= disable

= enable

If enabled, the system produces slow beeping from the keypads during

exit delay and reverts to rapid beeping during the last 10 seconds of the

exit delay.

NOTE:

The duration of the beeping is the programmed value of field *10

regardless of which entry/exit zone is used to exit the premises.

1*46

Auxiliary Output Mode

= ground start output.

= smoke detector reset.

= keypad sounds at an auxiliary sounder.

= AAV module.

Select the mode for output 1 on the J7 triggers.

NOTES:

Only one of the options may be active within the system.

Option 2 is available in the VISTA-128BP only.

Option 2 applies only to the partition enabled in field *15.

1*47

Chime on External Siren

(partition-specific)

= disable

= enable

If enabled, the system produces chime annunciation on the external

alarm sounder.

1*48

Wireless Keypad Assignment

= none

1-8

= partition number

Select the partition in which RF keypad is used.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 127 128

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-128B PLUS Especificaciones Pagina 70

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-128B PLUS