ADEMCO Vista-128B PLUS Especificaciones descargar pdf (Pagina 66)

VISTA-128BP/VISTA-250BP Installation and Setup Guide

5-6

FIELD

TITLE and DATA ENTRIES EXPLANATION

*52

Standard/Expanded Reporting

Primary

= disable

= enable

This field has six entries as follows: Alarm, Restore, Bypass, Trouble,

Open/Close, Low Battery. If enabled, expanded reports are sent to the

primary phone number if low speed format is selected in field *45.

NOTE:

Expanded overrides 4+2 format.

*53

Standard/Expanded Reporting

Secondary

= disable

= enable

This field has six entries as follows: Alarm, Restore, Bypass, Trouble,

Open/Close, Low Battery. If enabled, expanded reports are sent to the

secondary phone number if low speed format is selected in field *47.

NOTE:

Expanded overrides 4+2 format.

*54

Unattended Mode

= disable

= enable

If enabled, the system automatically calls the downloader at programmed

intervals.

NOTE:

The following fields must be programmed first: primary

subscriber account number – field *32; primary phone number – field *33;

downloader phone number – field *35. Or you can go into the Unattended

Program Mode, from normal operating mode, by entering Installer Code +

[#] + [8] + [9].

*56

Dynamic Signaling Delay

Enter

00-15

times 15 seconds.

Select the time the panel should wait for acknowledgment from the first

reporting destination before it attempts to send a message to the second

destination (first and second destinations are determined in field

✳

57).

NOTE:

If the acknowledgment is received before the delay time expires,

no message is sent to the second destination.

*57

Dynamic Signaling Priority

= Primary Dialer

= Long Range Radio

Select the initial reporting path for central station messages.

*58

Long Range Radio Central

Station #1 Category Enable

= disable

= enable

This field has six entries as follows: Alarm, Trouble, Bypass, Open/Close,

System, Test. If enabled, the reports are sent to the primary subscriber

ID of the Long Range Radio.

*59

Long Range Radio Central

Station #2 Category Enable

= disable

= enable

This field has six entries as follows: Alarm, Trouble, Bypass, Open/Close,

System, Test. If enabled, the reports are sent to the secondary subscriber

ID of the Long Range Radio.

*79

Zone Type Restores for Zone

Types 1-8

= disable

= enable

This field has eight entries, one for each zone type. Select the zone types

that will send Restore reports.

*80

Zone Type Restores for Zone

Types 9, 10 and 16

= disable

= enable

This field has three entries, one for each zone type. Select the zone types

that will send Restore reports.

*83

First Test Report Time

Enter

00-07

the for day (01 = Monday)

Enter

00-23

for the hour

Enter

00-59

for the minutes

Enter the day and time that the first Test report shall be transmitted.

Enter

in all locations if the Test report is to be sent immediately upon

exiting. Enter

in the day location if the report is to be sent at the next

occurrence of the time that is set.

*84

Swinger Suppression (partition-

specific)

Enter

01-15

Enter

for unlimited reports

This option limits the number of messages (alarms or troubles) sent for a

specific zone in an armed period. The system automatically resets the

shutdown for a zone after 48 hours if there are no trips on any zone.

Must be

for UL installations.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 127 128

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-128B PLUS Especificaciones Pagina 66

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-128B PLUS