ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 51)

Vista 120 Training Guide 51

6.9 Garage Door Setup

Training Module

• Learn in zone required to trigger the relay driving the garage or roller door.

• Go to #93 and select “Device Programming”. Program the relay module address as set on

its dip switches.

• Exit “device Programming”.

• Select “Relay Programming”.

• Select the relay number you wish to program to pulse to garage door motor

• Select the “Action” – Closed for 2 seconds.

• Select the start event – Fault, followed by the zone list that you wish to assign the zone

from the 5804 to.

• Select the partition that the start function will occur in.

• No “Stop” programming is required as the relay is closed for 2 seconds

• No further programming is required in relay programming.

• After all relays have been programmed, upon entering “00” at the “ENTER RELAY NO”

prompt, you will be asked to enter a “Zone List”. If a zone list number was used to start or

stop relay, you must define the zone that belongs to that zone list as follows:

• Enter “Zone List” number assigned to trigger the door relay.

• Enter 2 digit entries followed by * for all zones that will be used to open the door. Finish

with 00*.

• Enter 2 digit entries followed by * for all zones that will be used to open the door. Finish

with 00*.

• Make sure that the 5804 has been assigned to a user.

• Exit program mode.

• Code + off the system.

1 2 ... 46 47 48 49 50 51 52 53

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 51