ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 47)

Vista 120 Training Guide 47

6.6 5827 Bi Directional Wireless Keypad

Training Module

• Install & program 5882 Wireless receiver(s) as per 5882 Instructions

• Ensure that a House ID has been assigned to the Wireless receiver(s)

• Terminate the 5800TM on the console bus. The 5800TM should be a minimum distance

of 3 metres away from the panel to stop any interference. The 5800TM must be

programmed as an unused address within the range of 28 through to 30. Cut the red

jumper for an address of 28, white jumper for 29 and both for 30.

• Enter program mode (Installer code + 8 + 0 + 0 + 0).

• Go to location #93 and select Device programming.

• Select the address of the 5800TM (28-30) and enable it as an “Alpha Console”.

• Exit “Device Programming” (00 = Quit).

• Go to 1* 48 and select which partition the keypad will operate (0 = disable).

• Exit programming mode *99.

A number of system functions must be programmed into the 5827BD.

• After the battery is fitted to the 5827BD, power the unit up by pressing the * key. The

yellow LED should blink.

• Enter console programming mode by depressing 1 and 3 simultaneously. The red and

green LED should blink.

• The systems 4 digit Master Code must be programmed by pressing

Ø 8 then the 4 digit code and #

• For Quick Key function of Arm and Chime but not Disarm enter

Ø 2 then the 4 digit code and #.

• The systems House ID must be programmed by entering

Ø * 9 and then the 2 digit House ID then #.

• The systems RF type must be programmed by entering

Ø * 5 8 for 5800 and then #.

• Exit program mode by entering

Ø * #.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 47