ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 39)

Vista 120 Training Guide 39

6.1 4208 Hard Wired Expansion Training Module

• Connect 4208 via twisted pair to the Polling Loop terminals, Positive + 24 and Negative – 25. Observe

Polarity.

• Set 4208’s DIP switch to select the appropriate block of 8 zones as Serial Numbered Zones

• Use console to enter programming mode: installer code + 8 0 0 0.

• Press, #93 to move to “Zone Programming” mode.

• Enter 1 to enter “Zone Prog?”.

• Enter the 3 digit Zone Number (010 – 128) and press *.

• A summary screen showing present configuration will be displayed.

• Press * to move to “Zone Response Type

• Enter required Zone Type

• Press * to move to Partition

• Enter the Partition this Zone belongs to (1 –8).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 52 53

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 39