ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 44)

Vista 120 Training Guide 44

6.4 5804 Bi Directional Wireless Remote

Training Module

• Install & program 5882 Wireless receiver(s) as per 5882 Instructions

• Ensure that a House ID has been assigned to the Wireless receiver(s)

• Terminate the 5800TM on the console bus. The 5800TM should be a minimum distance

of 3 metres away from the panel to stop any interference.

• The 5800TM must be programmed as an unused address within the range of 28 through

to 30. Cut the red jumper for an address of 28, white jumper for 29 and both for 30.

• Enter program mode.

Device Programming:

• Go to location #93 and select Device programming.

• Select the address of the 5800TM (28-30) and enable it as an “Alpha Console”.

• Exit “Device Programming” (00 = Quit).

Zone Programming:

• “Enter Zone programming”

• Select an unused zone from 010-128

• Program zone type as required (eg. 20= arm stay, 21= arm away, 22= disarm)

• Select partition and report code for remote key

• Select input type 5 (Button RF)

• Learn loop button being used on that particular zone by pressing button

• Console will display first transmission received

• Press the same button again

• Console will display “Confirmed”

• Repeat procedure for each of the 4 buttons on the remote

• To avoid “check” conditions, Loop C must learnt into the system.

• Leave program mode

User Code Programming:

• Proceed to program a user code

- mastercode + 8 + unused user (002-128) + new user code

• Select authorisation level required

• Open and close reporting (yes/no)

• RF button (1 = yes)

• Allocate the first of the 4 zone numbers used for the remote when prompted

• Loop 4 must be programmed into the system to avoid “check” conditions

• * See user programming instructions on page 34 for details.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 52 53

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 44