ADEMCO VISTA-120 Guia de preparacion Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 53
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
Vista 120 Training Guide
22
VISTA 120 PROGRAMMING FORM
Some fields are programmed for each partition (shown as shaded fields). See the PARTITION-SPECIFIC section for programming these
fields. Standard default (*97) values are shown in brackets [ ], otherwise default = 0.
*59 SELECTION OF CONTACT ID
MESSAGE DATA ON KEYPAD Alarms Troubles Bypasses Open/ System Test
BUS FOR SUBSCRIBER ID#2 [0][0][0][0][0][0] Close Conditions Reports
1=Yes; 0=No
*60 VERIFIED ALARM REPORT
[0]
ENABLE 1= Yes (Swedish requirement)
0= No
*61 ROBOFON VERSION OF
[0]
CONTACT ID 0= Yes (Swedish requirement),
0= No
*79 ZONE TYPE RESTORE ENABLES [0]
FOR ZONE TYPES 1-8 1 2 3 4 5 6 7 8
1=enable; 0=disable
*80 ZONE TYPE RESTORE ENABLES [0]
FOR TYPES 9/10 9 10
1=enable; 0=disable
*83 FIRST TEST REPORT TIME | | |
[Day 00; hour 12; min 00] Days 01-07 Hours 00-23 Min 00-59;
00 in all boxes=instant (Day 01= Monday)
*84 INTERMITTENT SENSOR Partition-Specific
SUPPRESSION
*85 ENABLE DIALLER REPORTS [0] Partition-Specific
FOR PANICS & DURESS
*86 REPORT/LOG ZONE TYPE 23 [0] 1=yes; 0=no
*87 ENTRY WARNING Partition-Specific
*88 BURG. ALARM COMM. DELAY Partition-Specific
*89 RESTORE REPORT TIMING [0] 0=Instant; 1=After bell timeout if zone is restored; 2=when system is
disarmed.
*90 SECONDARY SUBS. ACCT.# Partition-Specific
1*00 CONTACT ID REPORTING IN
[0]
ASCII THROUGH PRINTER PORT 1= Yes 0= No, event log usage
1*01 ASCII CONTACT ID REPORTING
[0]
WITH OR WITHOUT ACK 1= ACK not required 0= ACK required
1*02 ASCII CONTACT ID BAUD RATE
[0] 0= 1200 1= 2400 2= 4800
1*05 BYPASS ENABLE FOR FIRE ZONES [0]
1=yes, allow bypass of fire zones; 0= fire zones cannot be bypassed
1*06 SUPPRESS ALL KEYPAD DISPLAYS
[0]
WHEN SYSTEM IS ARMED 0= Yes; 0= No
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 52 53

Comentarios a estos manuales

Sin comentarios