ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 15)

Vista 120 Training Guide

3.2 Recommended Programming Procedure

The purpose of this document is to provide a quick and easy way to program your VISTA-120 system. A

recommended programming procedure is included, followed by a list of program fields with the corresponding

program group they belong to (Systemwide, partition-specific, scheduling, etc.).

Following the program forms are system layout worksheets. We recommend that you use these sheets to plan

your system before programming is performed. If you need further information about specific programming

options, see the VISTA-120 INSTALLATION INSTRUCTIONS.

Single Partition System

• The system default is for a single partition system. If you are setting up a single -partition system, the

partition-specific fields become Systemwide fields. Follow the steps outlined on page 3 of this

document for proper programming procedure.

Multiple -Partition System

• If you are setting up a multi-partition system, you must enter the number of partitions you are using in

data field 2*00. Follow the steps outlined on page 3 of this document for proper programming

procedure.

Make sure that one keypad is connected to the control and is set to device address "00."

RECOMMENDED PROGRAMMING PROCEDURE

The following is a step-by-step procedure recommended for programming your VISTA-120 system.

1. Set the keypads (and other peripheral devices) to the appropriate addresses.

2. Set factory defaults by pressing *97.

This will automatically enable keypad addresses 00-03, so be sure at least one keypad

is set to one of these addresses.

3. Program Systemwide (global) data fields.

Using the programming form as a guide, enter program mode and program all

systemwide programming fields. These options affect the entire system, regardless

of partitions. They include control options, downloader and dialler options, RF

options, event logging options, etc.

Note that field 2*00 (number of partitions) & field 1*32 (RF expander type)

must be programmed before continuing.

4. Program partition-specific fields.

Partition-specific fields can have different values for each partition. When the

systemwide fields have been programmed, program all partition-specific

programming fields by first pressing *91 to select a partition (while still in data field

program mode). Then enter the first partition-specific field number *09. The next

partition-specific field will automatically be displayed when you are finished entering

the value for field *09. To program the fields for the next partition, press *91, enter

the desired partition number, then enter field *09.

5. Use #93 Menu Mode for device programming.

Refer to the DEVICE PROGRAMMING section of the Installation Instructions to

assign keypad ID numbers and default partitions for each keypad, and to selectively

suppress certain keypad sounding options. Also use this mode to assign RF

receivers, relay modules, and the VIP module.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 52 53

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-120