ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 29)

Vista 120 Training Guide

NOTE: The following fields should be preset before beginning: 2*00 Number of Partitions; 1*32 receiver

type. In addition, receivers should be programmed via Device programming.

After programming all system related programming fields in the usual way, press #93 while still in programming

mode to displa

y the first choice of the menu driven programming functions. Press 0 (NO) or 1 (YES) in response

to the displayed menu selection. Pressing 0 will display the next choice in sequence. Menu selections are as

follows:

ZONE PROG?

0=No 1=Yes

For programming the following:

• Zone Number

• Zone Response Type

• Wired zone

• RF Zone

• Right/left Loop Zone

• Serial number RPM zone

• Partition Number for Zone

• Dialler report code for zone

SEQUENTIAL LEARN?

0=no 1=yes

For entering (enrolling) 5800 transmitter & serial number polling loop device serial numbers into

the system.

REPORT CODE PROG

0 = no; 1 = yes

For entering report codes for zones and all system conditions.

ALPHA PROG?

0=no 1=yes

For entering alpha descriptors for the following:

• Zone Descriptors

• Installer's Message

• Custom Words

• Partition Descriptors

• Relay Descriptors

DEVICE PROG?

0=no 1=yes

For defining the following device characteristics for addressable devices, including keypads, RF

receivers (4281/5881/5882), 4285 voice module and 4204 output relay modules:

• Device Address

• Device Type

• Device's Home Partition

• Keypad Options

• Voice Module

RELAY PROG?

0=no 1=yes

For defining output relay functions.

3.5 Programming with #93 Menu Mode

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 52 53

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-120