ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 16)

Vista 120 Training Guide

6. Use #93 Menu Mode for zone programming.

Refer to the ZONE PROGRAMMING section of the Installation Instructions to

program zone response types, assign right loop zones and wireless zones, assign

zones to partitions, and to program alarm report codes.

7. Use #93 Menu Mode for programming relays.

Refer to the RELAY PROGRAMMING section of the Installation Instructions to

program desired relay operation.

8. Program Communication options.

Refer to the COMMUNICATION PROGRAMMING section of the Installation

Instructions to load communication defaults and to program related fields. Then use

#93 mode to program report codes if necessary.

9. Use #93 Menu Mode for programming alpha descriptors.

Refer to the ALPHA PROGRAMMING section of the Installation Instructions to

enter zone and partition descriptors and a custom installer's message.

10. Use #93 Menu Mode for programming relay voice descriptors and custom word

substitutes.

Refer to the RELAY VOICE DESCRIPTORS section of the Installation Instructions

for further instructions for programming relay descriptors to be annunciated by the

4285 VIP module, as well as the CUSTOM INDEX section for custom word

substitutes.

11. Use #80 Mode for programming schedules.

Refer to the SCHEDULING section of the Installation Instructions to program

open/close schedules, temporary and holiday schedules, limitation of access

schedules, and time driven events.

12. Define user access codes.

Refer to SECURITY ACCESS CODES section of the Installation Instructions to

program authority level, O/C reporting option, partition assignments, and wireless

key assignments for each user.

13. Exit Programming Mode

Exit programming mode by pressing either *98 or *99. A second entry of *99 is

required if the exit is being done from fields 1*00 and above.

To prevent re-access to Programming mode using the Installer's code, use *98. The

only way to re-access Programming mode is by depressing both the [*] and [#] keys

at the same time within 30 seconds of power up.

Exiting by using *99 always allows reentry into Programming mode using the

Installer's code. Either way of exiting will allow access via downloading. Note that if

local programming lockout is set via downloading, programming mode cannot be

entered at the keypad.

SUMMARY OF PROGRAMMING COMMANDS

• To enter program mode, enter installer code + [8] + [0] + [0] + [0]

• To set standard defaults, press *97

• To set communication defaults, press *94 + one of the following:

*82=Ademco Expanded High Speed; *83=Ademco Contact ID

• To change to next page of program fields, press *94

• To return to previous set of fields, press *99

• To erase account & phone number field entries, press [*] + field number + [*]

• To assign zone descriptors, press #93 + follow menu prompts

• To add custom words, press #93 + follow menu prompts

• To enter Installer's Message, press #93 + follow menu prompts

• To exit program mode, press *99 OR *98: *99 allows re -access to programming mode by installer code.

*98 prevents re-access to programming mode by installer code.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 52 53

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-120