ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 50)

Vista 120 Training Guide 50

4204 Relay Programming Cont……

Training Module

• Press * to move to “START PARTITION” then enter the specific partition number (1-8).

• Press * to move to “STOP ZN LIST” then enter the zone list number (1 to 8) or 0 if a zone

list if not being used.

• Press * to move to “STOP ZN TYP” then, if a zone type/system operation is being used,

enter the appropriate 2-digit code as listed above.

• Press * to move to “STOP PARTITION” then enter the specific partition number (1-8).

• Press * to move to “RELAY GROUP” then enter 0 if groups are not used or the specific

group (1 to 8).

• Press * to move to “RESTRICTION” and enter 1 if the end user will be restricted from

accessing this relay group, if no enter 0.

• Press * to move to “RELAY TYPE” then enter 1 for 4204 relays or 2 for Power Line Carrier

(X-10) device.

• If 2 (Power Line Carrier) was entered, “HOUSE CODE” will be displayed. Enter the House

Code by keying 00 for A, 01 for B, 02 for C, 03 for D, 04 for E, 05 for F, 06 for G, 07 for H,

08 for I, 09 for J, 10 for K, 11 for L, 12 for M, 13 for N, 14 for O or 15 for P.

• If 2 (PowerLine Carrier) was entered at “RELAY TYPE”, a “UNIT CODE will be displayed.

Enter the numerical unit code (01-15)

• If 1 (4204) was enter, “ECP ADDRESS” will be displayed. Enter the relay module address

as set by its DIP switch (1-15).

• If 1 (4204) was entered at “RELAY TYPE”, enter the specific relay number (1-4).

• Press * to move to the “START” summary and if correct, press * to move to the “STOP”

summary and if correct, press * and then enter 00 at the “ENTER RELAY No” field to exit

RELAY programming.

After entering all relay menu items, up to eight (8) zone lists may be programmed.

• At the “ZONE LIST” prompt, enter the zone list number 01-08.

• At the “ZONE NUMBER” prompt, enter each two digit zone number to be included in the

zone list. Press * after each zone number.

• When all zones have been entered, enter 0 0 and press *.

• The console will display “DEL ZN LIST?”. Press 0 to save the zone list or 1 deletes that

zone list.

• The console will display “DLETE ZONE?” Press 1 to delete one or more zones in that

zone list. Enter 0 if no changes are necessary.

• If 1 is entered the console will display “ZONE TO DELETE?”. Enter each zone number to

be deleted; press * after each number.

• If 0 0 was entered at the “ENTER ZONE LIST”, the console will display “VIEW ZONE

LIST?”. Enter the zone list number that you wish to view.

• Press * to scroll through all zones in that list.

• Enter 0 0 to quit.

1 2 ... 45 46 47 48 49 50 51 52 53

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 50