ADEMCO VISTA-120 Guia de preparacion descargar pdf (Pagina 35)

Vista 120 Training Guide 35

4. Communications

Training Module

COMMUNICATION DEFAULTS (Program after all Zones are programmed)

• This enables all Zones to report

• This Enables all “Zone Types” to send Restores

• This does not Enable Zones Restores, Supervisory or System Reporting

To Load Contact ID communication defaults

• Whilst at 1

Level of Programming

• Press *94 to move to the second level

• Press * 83 to Load Defaults

• Enter “1” to Default to Contact ID (see Defaults on p.134 – 138 of V120a Installation & Setup Guide)

REPORT CODE PROGRAMMING

• Whilst at 1

Level of Programming Press #93 & enter Menu Mode

• Press #93

• Select Report Code Programming

• Press * to move to Alarm, ID Digit

• Answer No “0” to Alarm, ID Digit (These were enabled when the Contact ID Defaults were Loaded)

• Answer Yes “1” to Restore, Supv Codes

• Enter one Zone from Each Group of 16 Zones (001-016, 017-032, etc)

• Press * to continue

• Enter a “01” followed by a “*” to enable each report required (See above Table) or just press “*” to leave

disabled

• Repeat as required for each Group of 16 Zones by entering one Zone from the next group of 16 zones

• When finished programming “Restore / Supervisory Codes”, Enter “000” at the Zone number prompt.

• To Move to System Group #1 enter a “0” (No) when asked if you wish to Quit Report Menu

• Then Answer “1” Yes or “0” No to Program System Group #1

• To Enable these reports enter 1st digit as “01”

• 2

digit can be left as “00”

• When you have finished programming these report codes the system will prompt: Quit report Menu?

• To Enter System Group #2 Press “1” (Yes)

• Program as per System Group #1

4.1 Setting the Clock

• Enter Installer Code #63

• Enter value required and press * to move along

• See Page 142 – Installation Instructions

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 52 53

Sin comentarios

ADEMCO VISTA-120 Guia de preparacion Pagina 35