ADEMCO Security System VISTA-15CN Guia de preparacion descargar pdf (Pagina 88)

VISTA-15/VISTA-15CN Installation and Setup Guide

17–2

2. Zone List (ZL) is a group of zones to which the

Event

applies in order to

activate a particular device. Note that there are 3 output device-related

zone lists that can be programmed in

✱

81 Menu mode; when the selected

Event (alarm, fault, or trouble) occurs in any zone in the selected

START

zone list (1, 2, or 3), activation of the selected device will

START

Start by Zone Type or System Operation

1. If a System Operation, such as

disarming

any

fire alarm,

is to

activate the device, the appropriate choice would also be entered under

the

Zone Type

option.

Zone Type

is used independently of the

“EVENT/ZONE LIST” combination.

If a

Zone Type

is chosen, any zone of that response type going into

alarm, trouble, or fault causes the device to activate as selected in

“ACTION.” If the same

Zone Type

is also chosen for the STOP

programming, any zone of that type that restores also deactivates the

device.

If a

System Operation

is chosen (for example, end of exit time), that

operation causes the device to activate as selected in ACTION. The

different choices for

Zone Type

and

System Operation

are listed in

“Programming Output Relays and Powerline Carrier Devices” later in

this section, and in the Programming Form.

STOP (STP):

The

STOP

programming determines when and under what conditions the

device is deactivated. The following options are available:

Upon Restore of a Zone List

1. Restore Zone List (ZL): If a

Zone List

is used as the STOP event, the

device deactivates when all the zones in that list restore from a previous

fault, trouble, or alarm condition. This occurs regardless of what is

programmed to

START

the device; therefore, a "RESTORE ZONE LIST"

would normally only be used when a

Zone List

is used to

START

the

device.

Upon a Zone Type or System Operation

1. Zone Type/System Operation: Instead of using a "RESTORE ZONE

LIST," a specific zone (response) type or system operation action can be

selected to deactivate the device.

If a specific

Zone Type

is chosen, any zone of that response type that

restores from a previous alarm, trouble, or fault condition causes the

device to deactivate.

If a

System Operation

is chosen, that operation causes the device to

deactivate. The different choices for

Zone Type

and

System Operation

are listed in “Programming Output Relays and Powerline Carrier

Devices” later in this section, and in the Programming Form.

During normal system operation, you may START any device manually by a keypad entry of:

Code + # + 7 + n; or STOP it manually by a keypad entry of: Code + # + 8 + n, where n = the

device number to be controlled.

As a

minimum

, the ACTION

(

)

field must be pro

rammed for this manual action to be operative.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 131 132

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15CN Guia de preparacion Pagina 88

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15CN