ADEMCO Security System VISTA-15CN Guia de preparacion descargar pdf (Pagina 35)

Section 6 - Wireless Expansion

6–5

Transmitter Battery Life

Do not install batteries in wireless transmitters until you are ready to enroll the transmitters during

system programming. After enrolling, batteries need not be removed.

Batteries in the wireless transmitters may last from 4 to 7 years, depending on the

environment, usage, and the specific wireless device being used. Factors such as humidity,

extreme temperatures, as well as large temperature variations may all reduce the actual

battery life in a given installation.

The wireless system can identify a true low-battery situation, thus allowing the dealer or

user of the system time to arrange a change of battery and maintain protection for that given

point within the system.

Some transmitters (e.g., 5802, 5802CP, and 5804) contain long-life but nonreplaceable

batteries, and no battery installation is required. At the end of their life, the complete unit

must be replaced (and a new serial number enrolled by the control).

Button-type transmitters (such as 5801, 5802, 5802MN/MN2, 5802CP, and 5804) should be

periodically tested for battery life.

The 5802MN and 5804 Button Transmitters have replaceable batteries.

Using the Transmitter Sniffer Mode

To use the transmitter Sniffer mode, perform the following steps:

Enter Installer code (4112) + # + 3 on keypad. This initiates a procedure that verifies

that all transmitters have been properly programmed.

The keypad displays all zone numbers of wireless units programmed into the system.

Fault each transmitter in turn, causing each one to send a signal, rather than let each

transmitter send an automatic supervisory signal.

As the system receives a signal from each of the transmitters, the zone number of that

transmitter disappears from the display. The transmitters may be checked upon

installation, or in an installed system.

After all transmitters have been checked, exit the Sniffer mode by keying 4112 (Installer

code) + OFF.

NOTE: Sniffer mode does not automatically expire. You must manually exit Sniffer mode

by keying Installer code + OFF key to return to normal operation. Sniffer mode also

terminates if a user arms the system from a console or a compatible wireless keypad.

Use of any RF devices other than a wireless keypad while in Sniffer Mode may cause

unpredicable results.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 131 132

Sin comentarios

ADEMCO Security System VISTA-15CN Guia de preparacion Pagina 35