ADEMCO Security System VISTA-15CN Guia de preparacion descargar pdf (Pagina 124)

VISTA-15/VISTA-15CN Installation and Setup Guide

B-2

California State Fire Marshal (CSFM) 24-Hour Battery Back-Up Requirements

The California State Fire Marshal has published new regulations which require that all

residential fire alarm control panels installed after June 30, 1993 must be provided with a

back-up battery which has sufficient capacity to operate the panel and its attached

peripheral devices for 24 hours in the intended standby condition, followed by at least 4

minutes in the intended fire alarm signaling condition.

This control panel can meet these requirements without using a supplementary power

supply, provided that the panel's auxiliary power and bell output currents are limited as

indicated in the following table.

OUTPUT LIMITATIONS TO MEET CSFM 24-HOUR BATTERY BACK-UP REQUIREMENTS

FOR UL LISTED RESIDENTIAL FIRE INSTALLATIONS

OUTPUT CURRENT LIMITATIONS BATTERY INFORMATION

OUTPUT CURRENT

TOTAL

MAXIMUM

AUXILIARY CURRENT

BATTERY CAPACITY

TO USE (Amp/Hrs)

RECOMMENDED BATTERY

(Yuasa Model No.)

600mA maximum total

auxiliary power

plus bell output

currents.

45mA

160mA

200mA

425mA

4AH

7AH

8AH

14AH

NP4-12

NP7-12

NP4-12 (two)

‡

NP7-12 (two)

‡

Note: Use two batteries, connected in parallel. Obtain an ADEMCO No. 4100EOLR Resistor Kit. A dual battery

harness is provided with the kit. The kit also contains EOL resistors with spade lug/heat shrink tubing

construction which has been approved by UL and CSFM for fire zone usage. Both batteries will fit inside

the panel's cabinet.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 130 131 132

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15CN Guia de preparacion Pagina 124

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15CN