ADEMCO Security System VISTA-15CN Guia de preparacion descargar pdf (Pagina 81)

Section 16 - Zone Programming

16–5

ZT RC In: L

01 09

10 HW: 1

A summary screen appears, showing zone 01’s current

programming or default values.

ZT RC In: L

10 – – – : –

Enter the first digit of the zone number to be programmed. In the

example at the left, where zone 10 is to be programmed, the first

digit 1 is entered, followed by the 2nd digit 0. The display includes

dashes, as shown at left. If zone 8 were to be programmed, you

would press the 0 key, then the 8 key. You must always program

zones using two digits.

Use the [D] key to enter wireless keys. When the [D] key is

pressed, a special prompt is displayed that offers a series of default

templates for wireless keys. Go to the paragraph on page 16-7

titled “To Enter and Duplicate Wireless Keys” for the necessary

procedure.

ZT RC In: L

10 00 10 RF:

†

If you enter HW

(hardwired) or AW

(Auxiliary) for Input Device

Type, the next screen is

similar to the one above,

except that HW or AW is

displayed under “In.”

If you enter RF, BR, or UR,

a prompt for Serial and

Loop number is displayed,

as shown below.

↓

10 INPUT S/N: L

AXXX-XXXX 1

10 INPUT S/N: L

A022-4064

A display with that zone’s current programming appears.

Press [

✱] to continue.

Enter Zone Type (ZT), Report Code (RC), and Input Device

Type (In)

†

sequentially, but not the Loop No. (L).

Use the [A] (Advance) and [B] (Back) keys on the keypad to move

the cursor within the screen.

Use the [C] key to copy the previous zones attributes.

Press [

✱] if the existing information is acceptable. If not, you can

press the [#]

key to back up without saving.

Manually enter the serial number (found on the transmitter

label), by typing digits in the “X” locations, using the [A]

(advance) or [B] (back) keys as required. You can also perform

two open and close sequences; for button-type transmitters, that

means pressing and releasing the button twice.

NOTE:

If you want to copy the previous zone’s serial number,

press the [C] key.

Press [

✱] to advance to the loop number, then enter loop number.

Press [

✱] to accept the existing serial and loop number. If neces-

sary, press [#] to back up and re-enter or edit the serial number

before pressing [

✱] to save.

To Delete a Serial

Number →→

To delete an existing serial number, enter 0 in the loop number

field. The serial number changes to all 0's as shown.

10 INPUT S/N:

A000-0000 0

If you entered 0 in error, simply re-enter the loop number. The

serial number then returns to the display.

Press [

✱] to accept.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 131 132

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15CN Guia de preparacion Pagina 81

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15CN